Part Number: TL081H Tool/software: Hi Team
my customer find below IC pin name is different. could you help me check which one is correct? and do you have any plan to fix datasheet?
BRs
Brian
Part Number: TL081H Other Parts Discussed in Thread: LM321LV , TLV9001 Tool/software: Hello,
We are trying to find a simple 1 channel cost effective voltage follower opamp.
We intend to connect a voltage divider to the noninverting input and use the…
Part Number: TL081H I have a scenario where the TL081H will be supplied with a 18 VDC single voltage supply (Vss to GND). The output of this device goes to an external connector that is required to meet voltage transient specifications. From an LTSpice simulation…
Part Number: TL081H Other Parts Discussed in Thread: LM7705 , OPA320 , Hi Taru
We have used opamp TL081HIDBVR in our Design. Just a query if this opamp can work with below input voltage range
Input at non inverting terminal= 0V to 3.5V
SCH is attache…
Typical values are not guaranteed. The datasheet does not specify a maximum output swing for the TL081, so a higher output swing is not considered a functional change.
After the PCN, the TL081 uses the same die as the TL081H (with CMOS rail-to-rail outputs…
Part Number: TL081H Other Parts Discussed in Thread: TL071H , , TL084H , TL082H , TL074H , TL072H
What's the major difference between TL081H and TL071H? I'm wired about these two family.
Regards
Brian W
Part Number: TL081H Other Parts Discussed in Thread: TL081 , TL084H , TL084 Hello,
From datasheet SLOS081M is appears that output swing, especially positive for the new TL081H is close to the rail (500mV).
Old TL081 can go only 1.5V from the rails.
However…
Part Number: TL081H Other Parts Discussed in Thread: TL081 , TL072 , TL072H , OPA1642 , TL052 , , TL082 , TL082H
According to this technical note , The old JFET TL072 had increasing distortion with increasing source impedance, which I assume was also true of the…
The new die is identical with the TL081H and uses a different architecture, so the same offset adjustment mechanism is no longer possible. As far as I know, these pins are NC.
Part Number: TL074 Other Parts Discussed in Thread: TL081H Tool/software: A problem occurred where several TL074IDRs oscillated.
I'm investigating whether EOS is the cause, or if there is a problem with the circuit and the oscillation is caused by variations…