Part Number: TL103WA Other Parts Discussed in Thread: TL103WB , LM2904 , LM358 Tool/software: I read in the TL103WA data sheet that the outputs of the two op amps can swing to within 50mV of the -Vcc rail when pushing a 10k ohm load. I interpreted this…
Part Number: TL103WA Other Parts Discussed in Thread: TL103WB Hello!
Do we have SPICE or TINA model of TL103WA operational amplifier available. I could not find it. How can I request for the same?
Thank you!
Best Regards
Samir Gautam
Part Number: TL103WA Hi, TI expert
I have an inquiry regarding the TL103WA.
Please inquire as the maximum rating for the entire pin is not shown on the datasheet.
1. When Vcc = 5V, can I check the Maximum Voltage Range and Maximum Current Range…
Part Number: TL103WA Hi team,
As below waveform, there are 600mV ripple observed in TL103 pin3. Would please you help analyze this? We have tried 2 pcs device. The results are the same.
The configuration:
Bias=12V, +24V=24V
D7, R43 are remo…
Bret,
The report has useful information however it doesn't have enough information to pinpoint a failing pin. At this point, all we need is DC measurements for keyed, not keyed on all pins. If you have more than one suspect device, check the DC voltages…
Other Parts Discussed in Thread: TL103WA , TL072 , LM358
I am using channel 2 of TL103WA as a unity gain buffer (non-inverting). Vcc is 5V, Vee is gnd.
The input is 0.45V. The output of the buffer is connected to junction of an 8.5K resistor and…
Part Number: TL103WB Other Parts Discussed in Thread: TL103WA , Tool/software: Hi E2E,
1. My idea of the resistance of R52 is to perform a delayed action, so I enlarge the resistance. 2. When the resistance value of R52 is 180K, there will be a 2mV…
Other Parts Discussed in Thread: TL103WA , TL103W Hi Team,
Could you kindly suggest the TI solution for AP4310EMTR-G1,
meet constant current and constant voltage by two OPA, so this device includes Vref & OPA at same time, Do TI have the same ?
