Part Number: TL331B Other Parts Discussed in Thread: TL331 , LM339 , TL331LV , Tool/software: Hi team,
customer see in a fail rate around 7% that they saw all the input and output pins are pull high together with VCC, which is not the expected waveform…
Part Number: TL331B Other Parts Discussed in Thread: TL331LV , TLV1821 Hello,
is it possible to get the VCM, (input voltage range, datasheet, 6.8 Electrical characteristics, page 6/27), voltage in more detail ? Especially the (V+)-2.0V, is that valid at…
Part Number: TL331B-Q1 Other Parts Discussed in Thread: TL331-Q1 Dear Supplier,
Pls help to confirm whether TL331BQDBVRQ1and TL331QDBVRQ1 are same material, and whether they can be substituted for each other, thank you!
Part Number: TL331B Other Parts Discussed in Thread: LM2903 , LM2903B Hello,
The simulation model for the TL331B ( slvm937e.zip) seems to be the same as thatone for Lm2903 (slcj011e.zip)
Is the TL331B the single channel variant of Lm2903?
Part Number: TL331B Other Parts Discussed in Thread: LM339 Hi,here is a IEC61851/J1772 Interface circuit,th CP is 1kHZ square wave ,amplitude is ±12V.but the TL331B is powered by 3.3v,if the CP short with +12V power supply ,does the TL331B will be damaged…
Part Number: TL331B-Q1 Hello team,
What are the differences between TL331QDBVRQ1 and TL331BQDBVRQ1?
Do we have a document with the major differences?
Best,
Juan.
Part Number: TL331B-Q1 Other Parts Discussed in Thread: TL331 , Hi Expert,
Thanks a lot for your warm help.
My customer is selecting comparators recently.
At present, they are considering SN331QDBVRQ1 and TL331BQDBVRQ1.
However, I can not find the datasheet…
Part Number: TL331B-Q1 Hello team,
Sorry for the very basic question. This is general question for the comparator.
To compare the input voltage against the reference voltage, there are two circuits as shown below.
The output logic will become opposite…
Part Number: TL331B-Q1 Other Parts Discussed in Thread: TL331 , Is the same die used in both the TL331 and TL331B-Q1? We are seeing different behaviors when using one vs the other on our board.
Thank you.