Part Number: TLC072 Other Parts Discussed in Thread: TLC070 , , TLV2374 Hi Support Team.
In the Qualification Summary, the results of ESD-HBM and CDM are described as "See data sheet". However, the datasheet does not show the results of ESD.
…
Hey Cici,
I opened your archive project and also ran into some convergence issues. These are the steps I took to remedy:
1. Turn on autoconverge (this is located in Simulation Settings -> Analog Simulation -> Auto Converge -> Select All) 2. Remove…
Part Number: TLC072 I am looking to use the TLC072 as a unity gain buffer for lighting 0-10 volt control signals. It can boost the current which is needed when driving a large number of light fixtures. So far when I configure the TLC072 as a unity gain…
I'm not sure if anyone is still monitoring this topic since it's marked resolved, but can someone tell me how close to the positive rail the TLC072 can drive at a high output level? For example, if the IC is being supplied with 10.0 VDC, what is the maximum…
Other Parts Discussed in Thread: TLC072 , OPA2322 , TLC2272
Hello:
A designer at a TI focus account we call on sent this message: " We’re using the TLC072 . It turns out that with +/-3.15V supplies (the bottom end of our supply voltage tolerance…
Part Number: INA827 Other Parts Discussed in Thread: TLC072 Hello, we are working on a design using the INA827 instrumentation amp along with a TLC072. Currently, we are using an unused gate of the TLC072 for a voltage reference. The TLC072 needs some…
Hi Pavithra,
Yes, full operating condition means full operating temperature range. I looked into THS4052, this part will work for you but it's a high speed part (Slew rate = 240 V/us), it's more expensive and not a similar match for LM358. Some…
Other Parts Discussed in Thread: TLC071 , TLC072 , OPA1642 , OPA172 , OPA827 , OPA1688 Hello,
I am designing a new audiometer (for hearing testing) and our old design uses the TLC072 and TLC071 amplifiers in the output stage of the audio. I am wondering if…
Thank you Kevin for your time, I am just using it to create waveforms using arduino, it requires a buffer in voltage mode right? So why not use it in current mode if you are going to use an opamp anyway. I have a couple of OPA2107 and TLC072 lying around…
Hi Bruce,
It may be that the TLC072 begins oscillating when the 10' cable is connected. When some operational amplifiers break into oscillation they can drraw high current through their output stage, overheat, and then self destruct.
If the cable is not…