Other Parts Discussed in Thread: TLC084-Q1 , TLC082-Q1 Dear TI
I would like to get a recommendation(opamp).
inquiry 1
-protection fuction(output current limit protection , not to stop and auto-recovery)
-power supply 5V
-RIRO
-10~100kHz BW
-the smaller…
Hello,
Q1: Please confirm followings of datasheet SLOS510D are typo.
1. Table 1 should be as follows.
Phase margin: Figure 19, figure 20
Gain Margin: Figure 21, Figure 22
2. Y-axis of Figure 22 should be “G- Gain Margin – dB”…
hello Kai,
TLV9104 has been considered, currently, I used TLC084, but you know, it is so expensive, and I'd like to find a potential one with high performance-to-price ratio to pin-to-pin replace TLC084.
But in my circuit, TLV9104 does not perform…
Other Parts Discussed in Thread: TLC084-Q1 , TLC082-Q1 , TLC084 Hello,
Customer plan to use TLC082-Q1/TLC084-Q1 to amplify sensor signal from outside of ECU, so they have to consider OPAMP can withstand surge pulse from outside .
Please advice if TLC082…
Other Parts Discussed in Thread: TLC084-Q1 , TLC082-Q1 , TLC082 Hello,
One of my customer is trying to use TLC082-Q1 and TLC084-Q1 for ECU and they have to do examination about serge tolerance.
Please answer following questions from customer.
Q1:
Please…
Hello Kai,
Yes, I have noted TLV9102‘s ability of capacitance load. If change C10/C11 to 100pF, even remove these two caps, I still can not run the simulation properly with whole circuit.
If remove U2A， then it works. So i do't know what's wrong…
Other Parts Discussed in Thread: TLC084-Q1 , TLC082 Hello,
TLC082-Q11 and TLC084-Q1 datasheet is revised from revision B to C, and θ ja are changed as follows.
Q1:
TLC084-Q1 theta ja (new datasheet) is 40C/w and increased 1.5 times.
Please explain…
