Search tips
Showing 14 results View by: Thread Post Sort by
    Answered

  • TLC2201-SP: Can I tie NC pins to GND?

    Resolved
    Part Number: TLC2201-SP In space conditions due to ionizing radiation a charge is accumulated on any floating metal hence the NC pins should be tied to some known potential to avoid electrostatic problems. Are the TLC2201AMFKBQMLV NC pins floating and…
    • Resolved

  • RE: TINA/Spice/TLC2201: TLC2201

    Hi, These configurations are not quite the same. You are not considering the effect of the 2 100kOhm resistors on the divider (see figure below). Moving your ground point changes the resistance in your voltage divider. It also changes your input paths…
    • Answered

  • TLC2201-SP: Rad data?

    Resolved
    Part Number: TLC2201-SP Other Parts Discussed in Thread: TLC2201AM Radiation data for TLC2201-SP is currently unavailable. Are there any plans to make this data available?
    • Resolved

  • TLC2201-SP: TLC2201-SP radiation data, bias current vs total ionizing dose (TID)

    TI Thinks Resolved
    Part Number: TLC2201-SP I would like to know if there is total ionizing dose radiation data for the TLC2201-SP op-amp? I am interested in how the bias current and offset current vary with total ionizing dose up to 100 krad.
    • Answered

  • TLC2201-SP: Package Question

    Resolved
    Part Number: TLC2201-SP Hi, I'd like to verify the form factor of the package for this part. The pinout shows 20 pins as does the packaging and ordering information but the mechanical data shows 28 pins. Which number is correct? Thanks
    • Resolved
    • Answered

  • TLC2201-SP: Power Rail Verification

    Resolved
    Part Number: TLC2201-SP Hi, I'd like to verify the rails this part can operate from. It has an absolute maximum rating specified of +/-8V for the supplies and a maximum input voltage of 8V (to any input, with this referenced to the mid-point of the…
    • Resolved
    • Answered

  • TLC2201 pSpice model error in ADS 2014

    Resolved
    I download the spice model form TI website. Buit it returns error when simulating in ADS. The error is "element Vcm+ for remote current C[1] not found" anyone can help me?
    • Resolved

  • RE: TLC2202AM: Device marking different from what is on data sheet.

    Hi Alyssa, Here is the data sheet that was revised in 2001. It doesn't have any lot marking information, and unfortunately I don't know if we have a way to get that information. Are you just trying to verify it is not counterfeit? Regards, Mike …
    • Answered

  • Mistakes in "Op Amps for Everyone" noise section?

    Resolved
    Other Parts Discussed in Thread: TLC2201 , TINA-TI In Op Amps for Everyone , there's a section on noise calculations "Op Amp Noise Theory and Applications" which is hard for me to follow. I see a few obvious errors, so I wonder if this section is just…
    • Resolved
    • Answered

  • RE: TPSM846C24: IS TPSM846C24MOLR the material in a special process or is it specially designed to withstand radiation?

    Resolved
    Hi Jenny, As far as I know, TPSM846C24 module is not specifically manufactured to withstand radiation. You may find some SEE TI products here: e2e.ti.com/.../slyt532g.pdf

Didn't find what you are looking for? Post a new question.