Part Number: TLV3402 Other Parts Discussed in Thread: LM2903 , TLC372 Hi, my customer's schematic is as below: U2 is TLV3402.
The waveform of pin 2- yellow, pin 3- green, pin1-blue are shown below:
As we can see, pin2(IN-) is always higher than pin3…
Part Number: TIDA-00366 Other Parts Discussed in Thread: AMC1301 , OPA320 , TLC372 , UCC21520 Hello!
According to the schematic of TIDA-00366, at the starting point it's clear that bootstrap capacitors aren't charged.
So AMC1301 IC's used for three…
Part Number: TIDA-00366
Hello!
According to the schematic of TIDA-00366 , at the starting point it's clear that bootstrap capacitors aren't charged.
So AMC1301 IC's used for three-phase current sensing are not supplied because their VDD1 are supplied…
Part Number: TIDA-00366 Other Parts Discussed in Thread: UCC21520 , TIDA-00199 Hello,
According to the schematic of TIDA-00366 , at the starting point it's clear that bootstrap capacitors aren't charged.
So AMC1301 IC's used for three-phase current…
Other Parts Discussed in Thread: LMV393 , TLV1702 , TLC352 , TLC372 , LM393 The output of the LMV393 is open collector, but the datasheet recommends that the output voltage be Vcc + 0.3V Max.
I am looking to pull up the output to 12V. Can I do that?
Do we offer a Vcc > 12V dual open-drain comparator that will handle the case where a negative voltage may be applied to Vin (through a limiting resistor)? Would the TLC372-EP work with the < 1mA limited current mentioned above?
Other Parts Discussed in Thread: TLC393 , TLV1702 , TLC352 , TLC339 , TLC372 , TLC3702 Hi,
We are considering output voltage is unexpected when low VDD.
The output voltage should be low on this condition.
What is the VDD voltage to change output voltage high…
Other Parts Discussed in Thread: INA138 , TLV3401 , TLC372 , TLV3701 , TLV3012 , TLV3011 I have a sensor with supply voltage of 4.5 - 20 V cc , and and operating frequency of 1 - 2500 Hz and 100 ohms resistance. This signal we are currently reading (I SUPPLY )is…
Other Parts Discussed in Thread: TLC393 , TLC339 , TLC193 , TLC372 , TLC139 1. I have an application where I have to drive N-channel MOSFET depending upon signal from MSP430. Since MSP430 alone cannot drive the FETS, So I have put to op-amp between MSP430 &…