Part Number: TLC555 Tool/software: Hi,
We wany to check below date code is before or after PCN 20231130002.1.
Since this PCN add new fab site and process.
(1) D/C: 2401
(2) D/C: 2236
Thanks!
Jeff
Part Number: TLC555 Tool/software:
I designed a circuit using the TLC555IDR timer IC where a trigger pulse(from connector J301) switches its output high and it's output is connected to both an optocoupler and a GPIO(in a parallel sense). The optocoupler…
Part Number: TLC555 Hi E2E,
There're some question about TLC555 design.
For Monostable design. Is it required for input low time?
RA=10M ohm C = 1uF, is it maximum ? or could I set to 20M ohm + 1uF?
Part Number: TLC555 Tool/software: Hi team,
My customer wants to build a serial time delay structure. And totally based on the example schematic of our datasheet, but only with the first two TLC555.
They found that:
1. The first TLC555 sends a pulse…
Part Number: TLC555-Q1 Other Parts Discussed in Thread: TLC555 , TLV313 Hello
With TLC555, is it possible detect rising edge of the signal ?
Can somebody verify the TLC555 portion of the schematic used for generating a sq pulse of duration around 630ms…
Part Number: TLC555-Q1 Other Parts Discussed in Thread: TLC555 Tool/software: Hello,
Currently, in the process of using TLC555QDRQ1, we need to confirm some technical related issues, as described below:
Question 1: We use TLC555-Q1 to drive MOS (MOSFET…
Part Number: TLC555 Please tell me about the TI timer IC TLC555.
The 5pin CONT terminal allows voltage input from the outside, but are there any restrictions on the voltage range that can be input? Our customer would like to be able to vary the frequency…
Hi Carols,
I don't think that there is any more support over e2e that can resolve this issue. If you are able to reproduce the problem, the please re-submit the device to the quality team, and include a reference to this e2e post. We can help the…
Part Number: TLC555 Hello,
I want to use TLC555 as Astable multivibrator to generate 100KHz square wave with 50% duty cycle. I was using TI calculator in which the propagation delays were included to estimate the output frequency tolerance. I would like…