Part Number: TLE2062 My customer is asking the following about the TLE2062:
I am using the TLE2062AMDREP in an application where, in certain circumstances, I ground the VCC and VCC– rails in order to guarantee that the output is driven to zero. I had…
Other Parts Discussed in Thread: TLE2062 Hi,
As per datasheet the input capacitance is 4pF.
Can you please provide input differential capacitance and common mode capacitance separately?
Thanks.
Other Parts Discussed in Thread: TLE2061 , TLE2062 Hi,
As per datasheet the open loop impedance for TLE2061 and TLE2062 are different (280 and 560ohm), how to take care this change in Spice model from datasheet? For which device the spice model is provided…
Other Parts Discussed in Thread: TLE2061 , TLE2062 Hi,
As per datasheet the open-loop output impedance of TLE2061 and TLE2062 are 280 ohm and 560ohm respectively. But in TINA simulation I am getting open-loop output impedance as 140ohm. Can you please…
Hello Shihab,
The TLE2062 thermal calculations I provded were for a steady-state Tj condition. The thermal path from ambient to the device junction involves a series of the thermal impedances - resistances and capacitances - having individual time constants…
Other Parts Discussed in Thread: TLE2062AM Hi,
The open loop impedance of TLE2062AM is given as 560 ohm.
Why it is very less in Figure 23?
Thanks,
Shihab.
Other Parts Discussed in Thread: TLE2062M , TLE2062 , OPA192 , OPA2313 , OPA2376 , OPA2340 , OPA2141 , OPA2140 , OPA2314 I am using 1/2 of a TLE2062M as a comparator. I find that when the VID increases from 0 to 1 volt, the supply current goes from 0…
Rick;
It looks as if your op amps are being connected as difference amplifiers. To get good CMR, you need to match the resistors carefully.
For example U10-A has a 40.2k feedback resistor so R27 should also be 40.2k. Do the same with all of the…
Other Parts Discussed in Thread: TLE2062 On the TLE2062, it appears the Phase Margin is specified as 58 degrees at unity gain. there is a reference to Figure 3. Figure three has a circuit configuration for a gain of 100, output referred to the input.…
