TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel


Search tips
Showing 10 results View by: Thread Post Sort by
  • TLV2172-Q1: TLV2172-OUTPUT CURRENT

    robin gangopadhya18
    robin gangopadhya18
    Part Number: TLV2172-Q1 Hello: Pl see the schematic attached. We are trying to get approx 4mA current thru rx. Clearly, by setting vx, as an example, to 2.25v, rx=560 Ohm, we expect Vx to track vr. Thus bridge's total current will be 4mA. But…
    • over 4 years ago
    • Amplifiers
    • Amplifiers forum
  • TLV2172-Q1: short-circuit current definition

    Josef Warta
    Josef Warta
    TI Thinks Resolved
    Part Number: TLV2172-Q1 Hello Team, my customer has following question: In the datasheet (SBOS784C –NOVEMBER 2016–REVISED JANUARY 2019), short-circuit current is defined as shown below. I want to make sure that my understanding is correct, and I was…
    • over 3 years ago
    • Amplifiers
    • Amplifiers forum
  • TLV2172-Q1: About FMEA (open short) test data

    Tsukui Yusuke
    Tsukui Yusuke
    TI Thinks Resolved
    Part Number: TLV2172-Q1 Hi, Could you provide the TLV2172-Q1 Pin FMEA like follows? http://www.ti.com/lit/an/slva627/slva627.pdf Best Regards, Yusuke/Japan Disty
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • RE: TLV2372-Q1: GAIN OF STAGES

    robin gangopadhya18
    robin gangopadhya18
    Hello Mike: Appreciate the prompt reply. I must be misunderstanding the role of the input diodes in light of the following text: Unlike most op amps that are specified at only one supply voltage, the TLV2172-Q1 device is specified from 4.5 V to 36 V…
    • 3 days ago
    • Amplifiers
    • Amplifiers forum
  • LMV358-N-Q1: LMV358Q1MAXNOPB

    Mohana Krishnan M
    Mohana Krishnan M
    TI Thinks Resolved
    Part Number: LMV358-N-Q1 Other Parts Discussed in Thread: LMV358 , LMV358-N , TL972-Q1 , RC4580-Q1 , TL3472-Q1 , TL3472 , TLV272-Q1 , TLV2172-Q1 Dear Team, We are looking into the below part - LMV358Q1MAXNOPB Can this part handle +/-5V dual power…
    • over 6 years ago
    • Amplifiers
    • Amplifiers forum
  • UCC28740: Valley Switching is not observed

    Prem Ankitkumar Shah
    Prem Ankitkumar Shah
    TI Thinks Resolved
    Part Number: UCC28740 Hi, I am using UCC28740 for 24W LED driver application which is using DCM flyback converter in peak current mode control at primary side. please find the specifications below: Input voltage : 85V rms to 264 V rms : 120V DC to 374…
    • over 5 years ago
    • Power management
    • Power management forum
  • Answered
  • UCC28740: Start up problem

    Prem Ankitkumar Shah
    Prem Ankitkumar Shah
    Resolved
    Part Number: UCC28740 Hi, I am using UCC28740 for 24W LED driver application using peak current mode control. while start-up the IC is facing issue in which it gives VDD profile of triangle waveform between 21V and 7.6 V. I understand this is a fault…
    • Resolved
    • over 5 years ago
    • Power management
    • Power management forum
  • RE: UCC28951: Transformer heating shoot up gradually

    Venkatesh B
    Venkatesh B
    Hi mike O, Thanks for review. I herewith attached complete schematics of PFC,PSFB and controller schematics Kindly do review and share your valuable points please controller.pdf psfb_updated.pdf 4024.power.pdf Thank you venkatesh …
    • over 1 year ago
    • Power management
    • Power management forum
  • RE: OPA2210: Is there TI solution to replace AD8634HRZN

    Art Kay
    Art Kay
    to User473, I searched all the op amp portfolio with the parametric search (precision, general purpose, and high-speed). There are 6 options with temperatures of 150C and above (see attached). The best match is the OPA211-HT (210C max). This is the…
    • over 1 year ago
    • Amplifiers
    • Amplifiers forum
  • Answered
  • RE: TLV9051: General Voltage Follower Questions

    Ron Michallick
    Ron Michallick
    Resolved
    Hello Alexander, Op amps sorted by size. parametric-data (4).csv
    • over 3 years ago
    • Amplifiers
    • Amplifiers forum

Didn't find what you are looking for? Post a new question.

  • Ask a new question