Other Parts Discussed in Thread: TLV2211 Dear All,
I am getting a output of 0 to 20mv from a ceramic pressure sensor , would like to convert it to 0 to 5v for input to PIC , we intend to use TLV2211 for the same , kindly help us out with the circuit…
Part Number: TLV2211 Other Parts Discussed in Thread: OPA333 Hi,
Using the following circuit to build a board to evaluate the output noise mainly in 0.1~10Hz. Power supply single +3.3V is provided by battery. Finds that R1~R4 resistance has serious…
Does anybody know how much input capacitance these can handle when used as a I/V converter with a 100G Ohm feedback resistor?
Does the input capacitance influence the open loop gain?
Binal,
I will try your test in the lab. I need to order sample parts to do this test. If they arrive early , I can try on Friday, otherwise it will be Wednesday. The power supply is likely common to other circuits in board, so it is uncertain if the…
Hi Holger,
We're going to need a little more information. If you can let us know your supply voltages and what type of circuit configuration you have, that would be great. A couple devices that might be good places to start:
With low supply voltages…
Hi user4577981 ,
What was the program that you generated the 4-pole bandpass filter?
For the most part the design report is correct. However, I was not able to match the magnitude dB and phase response exactly. Enclosed is the simulation for the filter…
Part Number: OPA2192 Other Parts Discussed in Thread: OPA192 , OPA189 , OPA188 Dear all；
We uesd OPA2192 replace LT6011IS8, The performance of OPA2192 is better than LT6011, but the OPA2192 output signal noise is greater than LT6011，
Can you give…
Other Parts Discussed in Thread: ADS1248 , LMP90079 Dear Sirs,
Dear Bob (Benjamin),
while I am setting up the management of the ADS1248 (see other thread), another curious issue has come up.
We are manufacturing hundreds of boards using the schematic…
