Part Number: TLV2372 Other Parts Discussed in Thread: TLV9152 Hi Team,
Our customer is using the Webench Filter Design Tool but unable to design a TLV2372ID 3rd order butterworth sallen key low pass filter as shown here https://webench.ti.com/filter-design…
Part Number: TLV2372 Hi,
The input to the circuit given below is a sine wave with amplitude 5V (0V to 10V) and frequency 1.4k Hz.
It is a 3rd order Butterworth filter with cut off frequency of 60KHz at -3dB
Here I am getting the output of 5V (0V to 10V…
Part Number: TLV2372 Hi, support team
My customer has the questions as follow: When tlv2372 is used as the voltage follower, the peer input terminal is connected with 1.5V reference voltage, the span resistance is 10kΩ, and the output terminal has a ground…
Part Number: TLV2372 Hello,
could you please help to find documentation on TLV2372IGKR with information about marking on TOP and Back side of component, and also decoder of label on reel for same position?
Thank you in advance
Part Number: TLV2372-Q1 Dear TI community.
I have questions about multibrator behavior.
Multibrator was used for EV battery voltage measurements. The attached file is a circuit diagram and a measurement waveform. If only 12V low voltage is connected, it…
Part Number: TLV2372
Now use TLV2372(VDD=12V)to enlarge high level voltage of pwm from 3.3V to about 10.7V ，frequency range：1K--25KHZ
1.Is it necessary to connect a small capacitor in parallel with R1? if really need capacitor ,how much calculate…
Part Number: TLV2372-Q1 Team,
Could you please help by providing the following electrical characteristics for TLV2372QDRQ1:
Maximum Storage Temperature (°C)
Minimum Storage Temperature (°C)
Input Voltage (either terminal)
Common-mode input voltage…
Part Number: TLV2372 Other Parts Discussed in Thread: TINA-TI Tool/software: TINA-TI or Spice Models Hi Team,
Is it possible to change a setting in TINA so that I can get a Bode plot with actual magnitude on the y-axis instead of dB? I would like to see…