Part Number: TLV2401-Q1 Hello,
I am currently trying to choose an op amp with an input voltage of 5V-9V and a supply current of ~1uA. My question is with regards to the supply current, how is supply current defined because some datasheets in the general…
Part Number: TLV2401 Customer is using TLV2401 op-amp as Voltage amplifier in our design. When are checking the output characteristics of the op-amp, unable to understand Output current test condition comment . Can you please explain the test condition…
Part Number: TLV2401 Other Parts Discussed in Thread: TLV9001 ,
Hi, Common-mode input voltage Absolute maximum rating is not described in the data sheet. Could you tell me Absolute maximum rating or common-mode input voltage and IN+pin, IN-pin? Customers…
Part Number: TLV2401 Other Parts Discussed in Thread: TINA-TI , Tool/software: TINA-TI or Spice Models Hello,
I want to simulate the TLV2401 amp because I'm thinking about adding it to my product design. I have downloaded the attached spice model. It…
Part Number: TLV2401 Dear Sir,
If I design my TLV2401 op amp this way, is there any issue? Is there any problem if I put the op-amp this way? Need your professional advice.
Thank you very much.
Part Number: TLV2401 Hello,
I would like you to confirm whether input and output spec for TLV2401.
* According to datasheet, it seems that user can input both negative and positive supply.
However, when I check waveforms in datasheet, there is no figure…
Part Number: TLV2401 Other Parts Discussed in Thread: TLV2402-Q1 , , TLV8541 Dear Ti,
I am looking for DC-DC Converters which will be a load of TLV2401-Q1 Opamp. Vin from lowest as possible till 5.5V and Vout=3.3 V. The best choice will be buck-boost converter…
That recommendation is wrong; the TLV9101 is not a slow, low-power opamp.
The speed scales with power. Low-power alternatives would be the TLV2401/TLV6003 (5.5 kHz, 0.9 µA), OPA251 (35 kHz, 27 µA), or OPA244 (430 kHz, 50 µA). There is no reason to replace…
Part Number: TLV2401 Dear sir,
Excuse me. I measured the input offset voltage of TLV2401 on TI EVM board by the topology below. (VCC=5V)
The measured offset voltage of one sample is about 400uV, but the other one is about 1200uV.
I know the input offset…