Part Number: TLV2548-EP Other Parts Discussed in Thread: TLV2548
Tool/software:
Hi everyone,
May I ask if the TLV2548IPWR needs to distinguish between digital ground and analog ground? Why do some ADC chips have dedicated digital ground and…
Part Number: TLV2548-EP Other Parts Discussed in Thread: TLV2548 Tool/software: Hi all,
What are the differences between TLV2548 and TLV2548-EP? The specific order codes are TLV2548IPWR and TLV2548MPWREP.
I already know that the temperature is different…
Part Number: TLV2548-EP Other Parts Discussed in Thread: TLV2548 , , TMS320F28377D Hello,
I have a question about the TLV2548 chip, which behaves differently depending on whether it is operating at room temperature or at a low temperature.
We are…
Part Number: TLV2548-EP Other Parts Discussed in Thread: TLV2548 , TLV2544 , TLV1544
Is the number of channels of TLV2548-EP 4 or 8?
The datasheet says:
"The 4/8 analog inputs and three internal test inputs are selected by the analog multiplexer…
Part Number: TLV2548-EP Other Parts Discussed in Thread: TMS570LC4357 ,
Hello,
I would like to integrate external ADC TLV2548-EP with TMS570LC4357 SPI4 channels.
Please confirm whether the unused FS, nCSTART and nPWDN can be tied to VCC pin.
Attached…
Part Number: TLV2548-EP Other Parts Discussed in Thread: TLE2022 , TLV2548 I am getting some unintended adjacent channel to channel coupling between an input channel of maximum input voltage (say 4.095V), and the adjacent channel of 0V.
The inputs…
Part Number: TLV2548-EP
The Device has only one supply pin. What is the SDO and EOC/nINT voltage level? The that sheet shows the VOH (min). But it does not tell me if the pin has no load. In normal usage, the input port of its master device is in high…
Part Number: OPA211-EP Other Parts Discussed in Thread: TLV2548-EP , Hi Team,
I have question about how to select a buffer amplifier for TLV2548-EP. I used Analog engineer's Calculator and input some spec of the TLV2548-EP.
Could you check my filling…
Part Number: TLV2548-EP Hello,
My customer has aquestion about TLV2548-EP.
[Q]
What is the ESD voltage of TLV2548-EP? (HBM and CDM)
Best Regards,
Kaede Kudo
Part Number: TLV2548-EP How do I Set the timing for the CS signal WRT SCLK? The recommended operating conditions suggests that the delay from the 16th falling edge of SCLK to the rising edge of CS should be a minimum of 0.5 SCLKs, which means (I think…
