Search tips
Showing 43 results View by: Thread Post Sort by
    Answered

  • TLV271: TINA simulation results conflict with reality

    Resolved
    Part Number: TLV271 Other Parts Discussed in Thread: TLV9151 Hi, I have a TINA simulation of the TLV271 in a differential amplifier configuration. The simulation worked well however the actual circuit does not. It appears that the simulation generates…
    • Resolved

  • TLV271: lowest input voltage if part is NOT advertised as rail to rail input

    TI Thinks Resolved
    Part Number: TLV271 Hi, If the TLV271 is NOT specified as a rail to rail input part, what is the lowest voltage the (+) input pin can be driven and we would expect the output to track the expect voltage if the opamp is configured in a differential amplifier…
    • Answered

  • TLV271: Diode for over voltage input protection

    Resolved
    Part Number: TLV271 Hello, i want to use a TLV271 as voltage buffer with a single supply voltage of VDD=5V. It is not guaranteed, that the voltage at the positive input of the OP-AMP is within the maximum rating of VDD+0.2 according to the datasheet,…
    • Resolved

  • TLV271-Q1: Slew rate spec

    TI Thinks Resolved
    Part Number: TLV271-Q1 Other Parts Discussed in Thread: TINA-TI , TLV271 Hi All, I have a question about the specs on the TLV271Q datasheet. Have you checked the above contents with the same circuit diagram as the one below? Any special schematics? …
    • Answered

  • TLV271-Q1: Part marking variation

    Resolved
    Part Number: TLV271-Q1 What is the meaning of the small lasered bars in on the component? Pin one mark in the line across the device body. In question are the short lines near the package mold borders, and above and below the 271Q part marking? There…
    • Resolved

  • TLV271-Q1: Please tell me, at which assembly process step is this device marked at TI?

    TI Thinks Resolved
    Part Number: TLV271-Q1 Is the part marked after molding (symbol) or after final test (LIS)? Can you tell me what "LIS" stands for in the process flow?

  • TLV271: AC voltage sense error due to ripple in actual voltage

    TI Thinks Resolved
    Part Number: TLV271 I have a system with mains supply given to a diode bridge rectifier followed by a capacitor and inverter circuit. Now I want to measure the mains voltage. To do that I am sensing the voltage across (Phase and DC Link -ve) and (neutral…

  • TLV271: TLV9041: Thickness of Gold in NiPdAu plating

    Part Number: TLV271 I was looking at the TLC271BID, and I need to know the thickness of gold in each part to determine the solderability without degolding the terminations. I found the information at the link below, but without knowing the total surface…
    • Answered

  • TLV271: ESD data request

    Resolved
    Part Number: TLV271 Other Parts Discussed in Thread: TLV9151 Hi Support Team. In the Qualification Summary, the results of ESD-HBM and CDM are described as "See data sheet". However, the datasheet does not show the results of ESD. Please tell…
    • Resolved

  • TLV274: Wave form distorted during simulation

    Part Number: TLV274 Other Parts Discussed in Thread: TLV271 Tool/software: I was simulating a circuit that uses a TLV274IPW. I used the TLV271 pspice file in a Tina TI simulator. I am getting a distortion on the voltage output waveform. I am not sure if…

Didn't find what you are looking for? Post a new question.