Search tips
Showing 54 results View by: Thread Post Sort by

  • TLV271/TLV272 Quiescent Current

    Other Parts Discussed in Thread: TLV271 , TLV272 Hi, Good day! Anyone here knows the typical and maximum quiescent current of TLV272/TLV271 operational amplifiers? Appreciate your favorable response. Thanks, Joemir

  • Spice model of TLV272

    Hi all, I could not find the spice model of this op amp neither in TINA nor in its specification TI web page... Is there any "hidden" one? Thx
    • Answered

  • TAS5508: TAS5508

    Resolved
    Part Number: TAS5508 Tool/software: Hi, In the TAS5508 datasheet there is an example schematic showing the connection to 2 Channel Line Out (TLV272) using PWM_P and PWM_M lines. Could I ask for a schematic of the 2 Channel Line Out (TLV272) module…
    • Resolved

  • TMCS1101: Power on Time delay

    Part Number: TMCS1101 Other Parts Discussed in Thread: TLV272 , Hi all , I am using the TMCS1101A2BQDR IC in our 3 Phase Inverter for motor control application for phase current sensing. I am facing an issue regarding the IC power on time. I have observed…

  • TL082: TL082

    Part Number: TL082 Other Parts Discussed in Thread: TLV272 , LM358 , Dear sir We are using Opamp TLO82C in our design as difference amplifier having 0.5 gain. The op amp is not working properly and not giving the difference of signal. For example…

  • RE: TL062: I need high impedance inputs

    Alvin, For PDIP, low IB, and 12V supply try TLV272 with input range down to ground. For rail to rail input, try TLV2372. Both suggestions are rail to rail output.
    • Answered

  • RE: LM5176: Using LM5176 as Battery Charger it happens that there is an unwanted reverse current flow

    Resolved
    Dear Brigitte, I mounted the new revision board with updated layout similar to EVM board and this time my boards works fine. I encountered another problem about the current limit, I used the same circuit that was working very well on the previous…

  • TL082: TL082

    TI Thinks Resolved
    Part Number: TL082 Other Parts Discussed in Thread: LMV358 , TLV272 , LM358 , LMP7702 , TLV9102 , OPA2990 Hi, i have an existing design that uses a TL082 as a volttage follower with high input impedance voltage divider in the range of 10m ohms and 1m…

  • LM5176: Difficult to find a stable COMP network to work using dinamic Vout change and current limit

    Part Number: LM5176 Other Parts Discussed in Thread: PMP10594 , TLV272 Dear Sirs., I write to receive Help to find a method for determining the best COMPENSATING network connected to COMP pin, so the LM5176 can work fine on the entire VIN (10V-30V)…

  • OPA2180: TINA-TI Simulation convergence issue

    TI Thinks Resolved
    Part Number: OPA2180 Other Parts Discussed in Thread: TLV272 , , TINA-TI , INA128 HI, I have a circuit which has a non-inverting amplifier followed by an instrumentation amplifier. NI amplifier is implemented with OPA2180 and instrumentation amplifier…

Didn't find what you are looking for? Post a new question.