Part Number: TLV274 The body marking check tool link doesn’t specify the expected or actual body marking wording and logo.
For example, we found part with TI logo, circle with a dot and circle only. Are all these different logos are expected marking…
Part Number: TLV274 Other Parts Discussed in Thread: TLV271 Tool/software: I was simulating a circuit that uses a TLV274IPW. I used the TLV271 pspice file in a Tina TI simulator. I am getting a distortion on the voltage output waveform. I am not sure…
Part Number: TLV274 Other Parts Discussed in Thread: OPA310 A few years back, we switched from TLV274CPW to TLV274IPW (industrial varsion). The circuit I have the opamp tied to is a reference signal or 4vdc (from an A/D). The op-amp is in a unitiy gain…
Part Number: TLV274 My understanding:
Maximum output Voltage swing if G=1 and 0V to +3.3V supply; (TLV274 has Common-Mode Voltage Range VCM 0V to (V+) – 1.35 V)
Would be 0V and +1.95V? (3.3V - 1.35V)
Using this op-amp in a filter circuit, where…
Part Number: TLV274 Other Parts Discussed in Thread: TMUX6219 , TLV9152 , TLA2024 Hello,
In our application we have 4 analog inputs. The primary inputs will always be present in the opamp input, but for a particular condition we have to cut the analog…
The DAC and input side of R7 is connected by a wire. There shouldn't be any loss. In the Tina circuit, VS1 shorts out the op amp U4 output. This is OK for simulation but bad if actually built. Setup the Tina circuit to be same as the built circuit. Then…
Part Number: TLV274 Hello team,
We can't find ESD rating via datasheet. Even can't find it via "Quality, reliability & packaging data download" page.
https://www.ti.com/quality-reliability-packaging-download/report?opn=TLV274IPW
Please help…
Part Number: TLV274 Other Parts Discussed in Thread: TLV9154 Hi,
We want to replace TLV274CPW by TLV9154IDR.
Can you please confirm ,we can directly use this without doing modification.
Part Number: TLV274 Other Parts Discussed in Thread: TLV271 I am new to PSPICE for TI. I have installed the program, opened, and built a simple model using the TLV271 (as recommended here ) and voltage sources on each of its inputs with the goal of confirming…
Part Number: TLV274
Hello,
On my custom design PCB, I use multiple TLV274 type OpAmps for doing Howland Current pump configurations. Among eight of them, only two of the TLV274 is over heating. All of them is power with +5V and -4.2V. I checked…
