Part Number: TLV2760 Tool/software: Hi Teams,
I am using the analog microphone on the BOOSTXL-AUDIO .
With my limited knowledge of the Analog Electronics, I would like to ask for help on understanding the function block on the schematic and the specific…
Part Number: TLV2760 Other Parts Discussed in Thread: TLV3012 Which is right drop-in TI alternate againstTC1039CECHTR?
https://ww1.microchip.com/downloads/en/DeviceDoc/21344b.pdf
Part Number: TLV333 Other Parts Discussed in Thread: LM2902 , LM324 , LMV321 , LMV321A , LM321LV , TLV9041 , LMV341 , TLV2760 , LMV601 Tool/software: I need OpAmp similar to the TLV333 that has no diodes from the input to the VCC.
So i can decrease…
Part Number: TLV341 Other Parts Discussed in Thread: TLV2760 Hello guys,
One of my customers is considering using TLV341 for their new products.
They want to know the amplifier turnoff time at /SHDN pin going low because they couldn't find it on the…
Harish,
I measured "Iq plus load current" for your circuit with a TLV2760 sample
The blue line is supply current (in micro amperes) vs. input voltage. Red line is Vout in volts.
The most interesting effect is that current drops when input overdrives…
Hello Shahaf,
The lowest power op-amp with a shutdown is the TLV2760 (28uA @ 500kHz), though it is 3.6V max. The next lowest would be the TLV2450 (42uA @ 220kHz, lower noise)
The LPV/TLV8xx series were designed for always-on applications. The current…
Other Parts Discussed in Thread: TLV2760 , LM2904 Hello,
May i know the Difference between Supply Current IDD and Is that is in DataSheet. And it is belonging for single Channel or Device.
Ximeng,
The op amp you are using does not have a sufficient gain-bandwidth product to provide a gain of 240 with a bandwidth of 10kHz. The gain * bandwidth of the TLV2760 is only 500kHz. The gain * bandwidth of your circuit is approximately 2.5MHz…
Part Number: TS3A44159 Other Parts Discussed in Thread: BOOSTXL-AUDIO Hi TI Team,
We have used the TS3A44159PWR (SPDT analog switch) in one of our projects and are observing that the IC gets heated and damaged (burnt) on some boards (not all) after…
