Part Number: TLV9062 Other Parts Discussed in Thread: TLV9061 i want to simulate the TLV9062 OP AMP with 3.3v I did not find this model in pspice could u please suggest these model
Part Number: TLV3202-Q1 Other Parts Discussed in Thread: TLV3202 Hi team,
I have an issue in using TLV3202 as a comparator. While testing I supply Non inverting input (IN+) with frequency signal of 50% duty (Typically fat Low - 0V to High-3.3V levels)…
Part Number: TLV3202-Q1 Other Parts Discussed in Thread: TLV3201-Q1 , Hello,
I have two questions on propagation delay time specs of TLV3201-Q1 or TLV3202-Q1.
TLV3201-Q1 or TLV3202-Q1's data sheet specifies its propagation delay times, t PD , but what…
Part Number: TLV3202 Hello,
I would like you to confirm about Vcc condition at figure 17(Propagation Delay Falling Edge) and figure 18(Propagation Delay Rising Edge).
* According to figure 17 and 18, output voltage is approx 5.2V (+/- 2.6V).
On the other…
Other Parts Discussed in Thread: TLV3202 , LM2904 , LM2903 , TLV3201 , LMV7272 Hi Team:
My customer use below circuit.
U145 if they use TLV3202, the DAO1(Comparator input pin) will be like below:
If they replace the TLV3202 with LM2904, the output will be…
Part Number: TLV3202 Other Parts Discussed in Thread: TLV3502 Support Path: /Product/Help with Device Selection/Amplifier/filter solution/ Good morning,
I'm designing an application based on a FPGA. The chip needs fast transition at its inputs pi…
Hi Lennon,
Unless a particular specification has a maximum, or minimum, specified in the Electrical Characteristics table, then we cannot state one. Doing so would infer that TI is assuring a levels of performance that reside outside the data sheet. A …
