Part Number: TLV342 Other Parts Discussed in Thread: TLV341 We will use TLV432 as amplifier for optocoupler secondary side.
In case the TLV432 doesn’t suppled, the primary side of optocoupler will still given energy that at the secondary side a current…
Part Number: TLV342S Other Parts Discussed in Thread: TLV342 , I am looking to use the TLV342S in place of a TLV342 due to part availability. If not used, does the shutdown pin need to be connected to VCC or can it be left floating?
Thanks
Part Number: TLV342S Hello support team,
I have a question about TLV342S.
A question 1. I think that the input impedance of the TLV342S hardly changes between with normal operation and at shutdown mode. (keep high impedance). Is my understanding corrent…
Part Number: TLV342 Hi, I'm looking for an op-amp to buffer a signal and provide an output of 2 -> 5V to a load of 100 - 200R. This would require driving the load with 50 - 100 mA. The TLV342IRUGR has a specified output source current of 115 mA, but I…
Part Number: TLV342 Other Parts Discussed in Thread: TIPD102 Hello!
I am looking for working schematic ideas to build constant current pulse driver, for medical application. Pulses are delivered to a driver by MSP430 MCU, for example 200 usec 20 pulses…
Other Parts Discussed in Thread: TLV342S , TLV342A , TLV342 Sir
Could you let me know Input offset voltage of TLV342S?
I could not find clear information in the data sheet.
is that the same as TLV342A? (1.25 mV (maximum) at 25°C)
or is that the…
Other Parts Discussed in Thread: TLV342 Hi,
The Supply Voltage of TLV342 is mentioned such following on the datasheet.
Absolute voltage and Recommended voltage is same (=5.5V).
I think that operating@V*=+5.5V is dangerous because the margin is…
Hi Herman,
the main problem is:
the Schema Schematic_with_NCS2001_TS331.sxsch is going well during simulation and when I change NCS2001 with TLV342 then the same simulation schema does not work and these errors occure:
*** ERROR *** Can not find…
