Part Number: TLV387 Tool/software: Hello support,
Datasheet of TLV387 specifies output swing limits of 30mV with Ta=-40'C to +125'C.
1. However, what is the linearity & output load in that condition? This is because high linearity output swing is…
Part Number: TLV387 Tool/software: Hello TI support,
I am working on one circuit of TLV387 where in AOL analysis reveals circuit to be stable with PM=75' when AOL=0dB. However, at 27dB there seems to be lower PM=~ 45. Transient analysis looks to be…
Part Number: TLV387 Tool/software: There is error in the Pin function table as it shows 6 pin for a 5 pin package part also it swaps the inverting & non inverting terminal pin numbers.
The figure that shows pinout for DBV Package, 5-Pin SOT-23 seems…
Part Number: TLV387 Hi,
I would like to know about the graphs in Figures 6-2, 6-3 and 6-4.
There are 5 graphs each, are they the values of 5 samples?
Best Regards,
Part Number: OPA2325 Other Parts Discussed in Thread: TLV888 , TLV387 I have an OPA2325 in non-inverting high gain mode taking sensor output and feeding into an ADC. I am specifically interested in 1-50 Hz signal integrity and see some noise on my input…
Part Number: OPA192 Other Parts Discussed in Thread: LM2664 , LM7705 , TLV387 Tool/software: Hi.
I have a problem with the OPA192.
OPA192 is used as a low impedance buffer to the input of the MCP2024 ADC.
From time to time, all of a sudden the…
Hi Luis,
Thanks for detailed explanation. I will apply for OPA325 samples for customer later.
So from my understand, this issue is caused by that OPA376 CMRR drops a lot with negative Vcm and high temperature?
And more, I have another question,…
Part Number: INA333 Other Parts Discussed in Thread: OPA391 , TLV387 , OPA333 , TLV333 , OPA387 , OPA187 Hello
I designed sEMG PCBA with INA333 as first stage of amplifier，first time I used the same SCH as bellow，and the ouput signal is correct.
The…
Hi Ohad,
The OP07 is a good, low-cost amplifier, but does have limited input and output range capability (input common mode needs to be 2 V higher than Vcc-). Depending on the input common-mode voltage, it may not work. Typically, for operation at 3…
And, I think I finished scanning the TI product trees for post 2015 <50MHz Introductions - omg, this is quite impressive, lot of work here to fill in the parametric fields, but this is the list I came up with the slightly modified descriptions - this…
