Part Number: TLV4113 Tool/software: Hi,
This IC has a short-circuit output current limit.
Am I correct in understanding that this function stops the output when the output current exceeds 800mA? Or does it clamp the output current at 800mA?
The…
Part Number: TLV4113 Other Parts Discussed in Thread: OPA1622 , INA1620 Dear Sir,
I am looking into the THD+N in Figure 16 on page 10 of the data sheet.
My headphone is specified at 16 ohm impedance, I attend to use TLV4113 as a headphone drive, however…
Well Steve,
The TINA model was just updated this year it appears, and yes the output swing does not match the data sheet - seems in error, there is a macromodel listing on page 17 for the original Boyle model if you need to go back to that,
Part Number: TLV4113 Hi Sir,
Our customer used the TLV4113 on product, But they are found out have glitch on AL_OUT in system Shutdown.
We have check open the output side, but not improve.
Can you give me some suggest for this issue?
Part Number: TLV4113 Other Parts Discussed in Thread: TLV4111 , TLV4110 When driving a 10 Ohm resistor on the output of the TLV4113 with a 1V output for 100 mA current. The input of the OpAmp was stable while the SHDN# was pulled high.
We note about…
Part Number: TLV4113 Received this part from one of your distributors. MFG C of C lists date codes as 52P2NVA and 21P09EA.
Trying to figure out how to decifer.
Other Parts Discussed in Thread: TLV4113 , TINA-TI Hi E2E,
My customer is worried about phase margin in our TLV4113. The datasheet states a phase margin of 8 degrees (which is concerning) but the spice model does not have stability issues. Do we have…
Other Parts Discussed in Thread: TLV4113 , OPA567 , OPA569 Hi,
An application requires couple of TI op amps for a new circuit design.
The parts that are interested: TLV4113, OPA567, and OPA569.
The part needs to drive has reasonably high continuous…
Other Parts Discussed in Thread: TLV4113 Hello Team,
I have a brief question regarding the TLV4113:
When the pins are biased such that Vdd = 0V and shutdown = 0V, will the part be damaged if the negative input gets an approximately 1.5V and less…
