Part Number: TLV6001-Q1 Tool/software: Hi team
regarding to the component information of TLV6001QDCKRQ1, the "mold compound" has been classified as "hidden" and told by the IMDS committee
can anymore provide the correct substance to replace "mold…
Part Number: TLV6001-Q1 Tool/software: Hi Team
i will have the new mass production for P/N: TLV6001QDCKRQ1
besides, i will need the below document as well for new production start up
1. IMDS ,
2. ICP (Laboratory test) ,
3. ChemSherpa ,
4…
Part Number: TLV6001-Q1 Other Parts Discussed in Thread: TLV9001-Q1 Tool/software: Hi,
My customer wants to use TLV6001-Q1 for high side current sensing.
Current range: 0-20 A
The MCU is a 5V interface.
Please advise on device value selection…
Part Number: TLV6001-Q1 Tool/software: Hi expert,
The Vos in datasheet is 4.5mV and in the figure 3, most of the values are around 2.5mV, and could not find the ratio about 4.5mV. That means the probability around 4.5mV is very very small.
However…
Part Number: TLV6001-Q1 Other Parts Discussed in Thread: TLV9001-Q1 , INA180-Q1 Hi,
Customer would like to use TLV6001-Q1 as Diff. Amp as below circuit.
Is each R value correct when using Diff. Amp?
If the value is wrong, please check the recommended…
Part Number: TLV6001-Q1 Other Parts Discussed in Thread: TLV9001-Q1 , OPA2991-Q1 , INA139-Q1 Tool/software: Hi,
The customer tried to place the shunt resistor in position 1 and sense the current.
However, VBAT is being entered at all times, causing…
Part Number: TLV6001-Q1 Dear TI experts,
My customer drew their 1st schematic with TLV6001-Q1. Could you review htis schematic?
And please let me know if you need more information for the review. Thanks.
Best regards,
Chase
Part Number: TLV6001-Q1 Other Parts Discussed in Thread: OPA348 , TLV6001 I used the suggested design from the filter design tool.
But the simulation in LTspice got abnormal results.
Part Number: TLV6001-Q1 Other Parts Discussed in Thread: TLV9001 , , TLV9001-Q1 , INA180-Q1 Hi,
The customer experienced a problem with the operation after configuring the circuit.
The circuit increased R101 (Rshunt) from 0.1 ohm to 1.4 ohm, but it…
Part Number: TLV6001-Q1 Hi all,
I am deploying the IC for designing a differential amplifier. However, on testing I observed that, it offers a linear gain if Vin+ > Vin-, but the gain is highly non linear if Vin+ < Vin-.
Requesting your support on…
