Part Number: TMUX1219 Other Parts Discussed in Thread: TLV7031 , TLV8542 , TLV7032 Hello,
With reference to page 15, Figure 10 (transition time) in the datasheet of TMUX1219, I would like to know the behavior of the TMUX switch, if the control voltage…
Part Number: TPS22916 Other Parts Discussed in Thread: LM66100 , TLV7032 , TLV1851 , TLV1861 Dear Texas Instruments Team,
I hope this message finds you well. I wanted to continue the discussion initiated in [ this post ], where I'm planning to employ…
I will provide updated information offline since this product is not released yet. In the meantime the push pull version, tlv7032 is currently available for sampling.
Chuck
Other Parts Discussed in Thread: OPA2333P , TLV7031 , TLV7012 , TLV7011 , TLV7032 , TLV4051
Hi Sir,
My customer would like design OP with the following spec.
low Iq, like( less than 10uA per channel),
Vin is 5.5V max
Vin is 2.5V min
Push…
After reviewing this further, I suggest you use the TLV7032 (dual, CMOS comparator with push-pull output stage) which reduces your package footprint by only having one package and it eliminates the need for the pull-up resistors. Everything is powered…
Hi Tony,
A window comparator is just two comparators sharing a common output. So hysteresis can be added to each channel.
But it does get complicated depending on the source impedance on the positive inputs, and how the reference voltages are generated…
AH
Most likely they will need to add external logic. If the application is still in design phase, it is easier to directly latch the output in non-inverting configurations by placing a diode in the feedback. Attached is an example of what I am referring…
Jesper
For devices with bipolar input stages such as the LMV331, VICR increases at temperatures above 25C and decreases at temperatures below 25C. Since the lmv331 can be operated down to -40C, it would be safe to assume that the VICR could shrink an…
Yanagawa-san
I have confirmed that the EC table is correct. The VCM range of -0.1V to 4.2V is for 25C only at 5V operation. The information in section 9.2.2.1 is a bit misleading because it does not refer to the operating voltage and it mentions over…
Hello Jian,
Seems that the first sentence is not too clear. The internal resistors are AFTER the ESD clamp diodes and before the internal differential clamp.
The ESD diodes are connected directly between the input and supplies, seeing the full current…
