Part Number: TLV840 Hello Expert:
My customer want to use TLV840 family device and need to design 1Sec reset delay request.
we checked the max delay option was 200mS (I verion) max as below Figure 5-1
However, we reviewed the CT pin can place 10uF…
Part Number: TLV840 Other Parts Discussed in Thread: TPSM81299 , Hello,
I'm trying to order PN: TLV840NAPL08DBVR . It's not recognized on the TI website. It's a valid PN per the datasheet. Any suggestions?
Part Number: TLV840 Hello,
I am redesigning a board with master/slave FPGAs that share ground and have several signal paths between them.
Each FPGA uses:
3.3 V from a buck converter
2.5 V from an LDO
1.2 V core from an LDO
When the master…
Part Number: TLV840 Tool/software: Hi,
My customer is using the TLV840. The timing in question is tD on the datasheet and is the delay from MR to Reset release. If we are using a 1uF, 10% capacitor connected to pin 5 (CT) and the datasheet indicates…
Part Number: TLV840 Hi,
We have been using the Rohm BD5328FVE-TR reset IC, but since it is going EOL, we are looking for a Texas Instruments alternative. https://fscdn.rohm.com/en/products/databook/datasheet/ic/power/voltage_detector/bd52xxg-e.pdf …
Part Number: TLV840 Tool/software: Hi
Could you help recommend a suitable RESET IC
Spec are as follows:
ADJ Best
If not, the fixed voltage is around 4.5V
ACTIVE HIGH/LOW both
Package SOT23 or other, the smaller the better
Part Number: TLV840 Tool/software: Hello TI Team,
I’m currently working on a design that uses the TLV840NADL20DBVR device, and I would like to simulate its behavior in PSpice for TI . However, I haven’t been able to find the corresponding SPICE model…
