Part Number: TLV9020 I understand that the TLV9020 has fault tolerant inputs that can handle being powered when the part does not have power. What is the worst case input current on these inputs under this condition?
Thank you.
Part Number: TLV9020-Q1 Hello,
While using TLV9020QDBVRQ1 as hysteresis comparator as inverting comparator, when the input voltage reaches near the VHL voltage, the output fluctuates. The output changes the state (from high to low), once the VHL threshold…
Part Number: TLV9020-Q1 Hello,
What is the min resistance in series that can be added to IN+ and IN- pins ?
Can we directly apply input signal to IN+ and IN- pins without series resistor? Or how much should be the current limiting resistor value…
Part Number: LMV331 Other Parts Discussed in Thread: TLV9020
Tool/software:
Hi Ti team
I designed a Hysteresis circuit using LMV331 to power off at high temperature and turn it back on when the temperature drops.
However, the Output swings before…
Hello Zevin,
The TLV1701 has traditional ESD diodes to the supplies on the inputs. These diodes would back-feed the supplies through the input. Current must be limited to under 10mA (we recommend <1mA).
We do have devices that have "failsafe" inputs…
Part Number: LMV331 Other Parts Discussed in Thread: TLV9020 , ALL HI.
As shown in the following picture. The chip specification is the description of the input common mode voltage, the maximum input common mode voltage can not exceed vc-0.7v, beyond…
Part Number: LMV7275 Other Parts Discussed in Thread: TLV9020 Hi,
I would like to use LMV7275MG/NOPB design as below schematic, could you please help to review and provide your comment.
Do you have relative OP design and need to check portions? If…
Part Number: LMV331 Other Parts Discussed in Thread: TL331LV , TLV9020 Tool/software: Hi team,
When only use pull up 3.3v logic voltage on output pin(4pin), but don't supply Vcc, we found LMV331 Vcc pin(5 pin) will get unexpected voltage about 1.7V…
Part Number: TLV3501 Other Parts Discussed in Thread: LM119 , , TLV9020 , LMV7235 , LM319-N , TXU0101 , SN74LXC1T45 , SN74LVC1G07 Hello,
Does TI sell a device similar to TLV3501 with an open drain output instead of push-pull? I do not see any comparators…
Piotr,
Alternative comparator TL331LV-Q1 is rail to rail input. It is a different pinout which shouldn't be a problem if the layout isn't set yet.
TLV9020-Q1 is available in in same pinout.
