Part Number: TLV9052 Other Parts Discussed in Thread: TINA-TI Hi Team,
Our customer wants to know the maximum voltage output swing from rail spec for TLV9052 for several hundred ohms load like 100~200ohm under 3.3V voltage, but from the datasheet, we…
Part Number: TLV9052 I have validated our circuit design using the TLV9052IDR package. I will probably use the TLV9052SIDGSR because a complete CAD model is available for this version of the TLV9052.
There don't appear to be any different electrical characteristics…
Part Number: TLV9052 Hi Team,
In our experiments,we found that the input voltage to the signal input pin was 5.54V, and the input current was 0.2mA.
Does this results exceed the absolute maximum ratings?
Best regards.
Part Number: TLV9052 Other Parts Discussed in Thread: LM10 , TLV9002 , TINA-TI
Hello,
I have built a very simple differential amplifier with the TLV9052. The inputs are 220K Ohm and the two feedback resistors are 470k ohm. The inputs connect to two metal…
Part Number: TLV9052 Hi team,
Would it be possible to provide long term drift data of offset voltage?
If TLV9052 doesn't have it, long term drift data of other GPAMP which has similar spec is also helpful.
If it can't be shared on E2E, please send…
Other Parts Discussed in Thread: TLV9052 , TLV9102 , TINA-TI I use Orcad Pspice i have down loaded TLV9052.cir and have tried to make a part and use the orcad tools as suggested by a Ti app note SLOA070 i get this error in Orcad when I try to use it in a …
Part Number: TLV9052 Other Parts Discussed in Thread: TINA-TI Hi Team,
I am using TLV9052 Dual Opamp as Amplifier and Comparator.
This is a very cost-sensitive system so each and every component matters to us.
If you see my Amplifier Circuit it is not…
Part Number: TLV9052 Other Parts Discussed in Thread: TLV9062 , Hi Team Our customer simulate TLV9052 and TLV9062 using the available Spice models for these devices. Everything looks great, except for the opamp doesn't actually output 0V when the input is…
Hi Ashley,
Thanks for detail answer, could you please let me know how you calculated 50ohm on TLV9052. Also, I see on your simulation you are suing V- as negative supply instead of GND.
Thanks