Part Number: TLV9104 Tool/software: Hi Team,
As title, when SD = '1'(disable), is Vo Hi-Z? In below block diagram, it looks like that output is push pull architecture which means it doesn't have default pull high or pull low state, is it correct?…
Part Number: TLV9104-Q1 Tool/software: Dear TI Support Team,
I am currently evaluating the TLV9104-Q1 operational amplifier for use in an automotive application.
While the datasheet specifies a typical slew rate of 4.5 V/µs, I could not find any information…
Part Number: TLC27M4 Other Parts Discussed in Thread: TLV9104 Tool/software: hi Team
I was checking for newer alternatives vs. TLC27M4.
The TLV9104 datasheet doesn`t specify maximum values of input bias current.
Could you comment about that (possible…
Part Number: TLV9104 Hello Team,
we are using TLV9104 for Unity gain amplifier. in which the nominal input voltage will be of 10V and the unity gain amplifier will be suplied with 12V. there is also one situation where the input voltage will be of 14V…
Part Number: TLV9104 We are currently using the op-amp in an application using an inverting amplifier configuration with the positive supply connected to ground and the negative supply connected to -5.2V. We only require negative output voltages from…
Part Number: TLV9101 Dear all,
I would like to ask about timing of starting mass production.
We have received a request from our customers for the following devices.
Please tell us when to start mass production of the following devices.
・TLV9101IDBVR…
Part Number: TLC2254 Other Parts Discussed in Thread: TLV9104 Tool/software: Dear Specialists,
My customer is considering TLC2254 and has a question.
I would be grateful if you could advise.
---
[Phenomenon]
In the output range of 1.45V or less…
Part Number: THS4531 Other Parts Discussed in Thread: TLV9104
we are using THS4531 to amplify differential signal. but it is observed that output is always stuck to the power rails.
gain of the circuit is configured as 2 (RF: 100K and RG:50K) and…
