Part Number: TLV9351 Dear e2e team,
I need to supply the TLV9351IDBVR with V+=+3.3V and V-=-5V: looking at the datasheet, at pag 7 table 6.1 there is Vsupply= V+ - V- = 0-42V, instead at table 6.3 is (V+) – (V–) = 4.5 V to 40 V (±2.25 V to ±20 V). …
Part Number: TLV9351 When the OPAMP GND shown in red in the design is broken, it pulls from the place shown in blue below and burn the OPAMP. This is a situation we do not want, it is acceptable for the OPAMP not to draw current, but it is unacceptable…
Part Number: TLV9351 Hello, I am actively using an opamp in the circuit I designed and I want the opamp to turn off its output when the gnd pin is disconnected. However, when the gnd pin is disconnected, the gnd leg of the opamp takes a positive value…
Part Number: TLV9351 Other Parts Discussed in Thread: OPA991 , TLV9151
hi, I have designed a howland current source using tlv9351. From the power rails of the opamp, the gnd pin is externally connected to the connector. When the gnd pin is removed, the…
Part Number: TLV9351 Hello,
we have a working design with TLV9351 acting as voltage follower.
Supply: single, Vcc=15V. The circuit input signal voltage ranges from -12V...+12V.
The input signal is connected to the IC input by a serial 100k resistor. At…
Part Number: TLV9351 Hi sir,
This is Bhuvaneswari from Zettaone Technology,
I need to know few details for the part TLV9351IDBVR
Parts are currently active in the website, may i know how long it will be in production? Is there any EOL issued for this part…
Part Number: TLV9351 Other Parts Discussed in Thread: TLV9051 , TLV9151 Hi sirs,
My customer designs TLV9351 with 5Vcc at V+, and GND at V- pins. However, the input signals is 3.2V around at IN+, IN- pins. from data sheet, it requires (V+ - 2). On this…
Part Number: TLV9351 How long does it take for the TLV9351 (or any other Amoeba device for that matter) to be up and running after power is applied?
Thank you!