Hey Nilabh,
Nilabh Anand said: I am also trying to reproduce it on my setup Nilabh Anand said: I checked this on my setup, I was able to figure out the issue .
Iam not quite sure if i understand you correctly, could you reproduce my issue or not? Because i…
Hi Marcel,
The datasheet isn't wrong. The mux mode is set correctly to GPIO55. But as you'll see, the Ball State after reset is set to 'off' so while the mux is set for GPIO55, the ball is inactive until configured by the program.
Best…
Part Number: TMDSCNCD263P Other Parts Discussed in Thread: UNIFLASH Tool/software: I am getting an error using the AM263P Control Card and Uniflash programmer. It is strange it says 0 of 32752 when the file size is 219.39 KB! Board: AM263P Control Card …
Part Number: TMDSCNCD263P Tool/software: Hi Shaunak,
Regarding the related question, I responded by email directly that you have provided scripts for off-chip trace trace not the regular JTAG scripts. Pls provide the regular Lauterbach debugger scripts…
Part Number: TMDSCNCD263P Other Parts Discussed in Thread: TCA6424 , TCA6416 , UNIFLASH
Tool/software:
Hello,
I am trying to get the TI example for OSPI communication working. There seems to be an issue with the OSPI driver setup in the flash_diag example…
Part Number: TMDSCNCD263P Tool/software: Hey, some time ago i found design files for this eval board. But i can't find them anymore, can someone provide a link? Moreover its not possible to import those design files to altium. I tried to import the…
Part Number: TMDSCNCD263P Other Parts Discussed in Thread: TCA6424 Tool/software: Hello Team,
we are working on MCAL version MCAL_AM263Px_09.02.00 for AM263Px
we are facing difficulty in establishing communication over MCAN4 on the EVB board
we referred…
Nilabh Anand said: Run Target is not implemented
Hi Nilabh,
OK, thank you. If I'm asked about this then I can at least quote your response that it's not implemented.
Is there a plan to implement 'Run Target'?
Meanwhile, we shall arrange…
Part Number: TMDSCNCD263P Tool/software: Hi, My customer has a question for power tree. Below is Figure 2-6 in users guide (spruj86c.pdf). VSYS_1V2 is generated from BB_OUT(6V) using buck converter. Is there specific reason why PMIC does not generate 1.2V…
