Part Number: TMP275-Q1 Other Parts Discussed in Thread: TMP275 , TMP112-Q1 Tool/software: Dear TI Team,
I would like to request the pin Failure mode analysis data(FMA) for the TMP275-Q1 device for compliance and documentation purposes. Kindly share…
Part Number: TMP275-Q1 Other Parts Discussed in Thread: TMP275
Is it possible for the device to be in shut-down mode initially and then triggered to do a One-Shot conversion? What are the ramifications of triggering a one-shot conversion by setting…
Part Number: TMP275-Q1 Other Parts Discussed in Thread: TMP275-Q1 , TMP275 Hi everyone! My project is about exercise therapy for disabled people. The structure works, but we will develop with skin measurement. I want to measure the skin surface temperature…
Part Number: TMP275-Q1 Hi,
About power-up condition, Is there any minding point to operate power on reset normally?
For example, tOFF, tR, Vbot is as followings .
I'm recognizing that there is not description on the datasheet.
Best Regards,…
Hi Piyush,
The TMP117 is not available as Q100 auto qualified, that is probably why Josh was asking.
If you really don't need the accuracy of the TMP117 then I would take a look at something like the TMP112-Q1, TMP102-Q1, or the TMP275-Q1. These are…
Part Number: MSP430F5529 Other Parts Discussed in Thread: TMP275-Q1 , TMP275 , Tool/software: TI C/C++ Compiler Hello all, I'm relatively new to MSP430 and microcontrollers as well as this forum. I'm currently trying to code my MSP430 to read from a TMP275…
Hi Jonathan,
I'm trying to get these pushed to TI.com but I have attached them here for your use.
Regards, Bill
Daughtercard BOM
am335x_gpevm_gpdboard_3H0001_bom_rev1_2b.xlsx
LCD card BOM
am335x_gpevm_lcdaboard_3H0005_bom_rev1_3a.xlsx
Hi Chen,
Here is a copy of a TMP112 datasheet revision which still had the slope information (See section 8.1.1). Keep in mind that while the information in this section should still be correct, this datasheet revision itself is now considered obsolete…
Miyazaki-san,
Takayuki Miyazaki said: After that, customer did " echo Test > /dev/ttyS1", it still failed. Is there any other check-points for this?
Where did the customer try to connect to the UART1 signals (AM335X_UART1_TXD @ ball D15, AM335X_UART1_RXD…
