Part Number: TMS570LS0332 The datasheet writes ...
"In the Terminal Functions table below, the "Reset Pull State" is the state of the pull applied to the terminal while nPORRST is low and immediately after nPORRST goes High. The default pull direction…
If 0x 03000503 is located at 0x10000, and 0x3C000000 is at 0x1000C
0x10000 --> 0x03000503
0x10004 --> 0x00000000
0x10008 --> 0x0000C261
0x1000C --> 0x3C000000
The ECC is 0x92, and 0xE8
If 0x 03000503 is located at 0x10000, and 0x3C000000 is at 0x1000C
0x10000 --> 0x03000503
0x10004 --> 0x00000000
0x10008 --> 0x0000C261
0x1000C --> 0x3C000000
The ECC is 0x92, and 0xE8
Part Number: TMS570LS0332 Hi,
I cannot find in the datasheet if the Kelvin GND of the uC can/shall be connected to the ground of the UC.
Do you have also a layout guideline for the crystal for best inmunity? Should we have a local ground for this kelvin…
Part Number: TMS570LS0332 Other Parts Discussed in Thread: HALCOGEN The code solution for the issue SSWF021#45 in errata SPNZ226A can be generated in HaldCoGen tool.
We are not using the DCC module, so the issue DCC#24 is not affecting us.
Question:…
Part Number: TMS570LS0332 Tool/software: Code Composer Studio Hi all,
Last week QJ Wang gave me the advice to buy a XDS100v2 to flash my TMS570LS0332 chip. The XDS100v2 has a 14-pins pinout and I use a 20-pins JTAG pinout for my embedded system. When…
Part Number: TMS570LS0332
Tool/software: Code Composer Studio
We are using our functions to check flash CRC.
Also, we have enabled the ECC core for check ECC erros in flash.
The issue: We have a abort exception error: ATCM ECC Error if the Size input…