Part Number: TPA2000D1 Tool/software: Hi team,
Are there any ways to control the output power of TPA2000D1 by TPA2000D1 itself? My customer would like to connect 1W speaker to TPA2000D1.
Best regards,
Shunsuke Yamamoto
Part Number: TPA2000D1 Tool/software: Hi team,
I have a question regarding the short circuit protection. Based on the e2e thread below, short-circuit protection is enabled by exceeding the threshold.
1. What is the threshold? Current? or voltage?…
Part Number: TPA2000D1 Other Parts Discussed in Thread: TPA6211A1 , TPA2011D1 Tool/software: Hello,
I need to drive a 3 ohm load with a +/-1Vpp signal with input frequency from 1 to 600Hz.
Can you recommend a starting point for this design? Is this…
Part Number: TPA2000D1 Other Parts Discussed in Thread: TL082 Hello,
I'm trying to amplify a white noise with a TPA2000D1 (more precisely, I have to use six TPA2000D1 to obtain six independent outputs).
Main schematic:
Noise source is built with…
Part Number: TPA2000D1
Hi Team
What is the thermal resistance and how to calculate the junction temperature of TPA2000D1?
It is better to give the calculation method and specific value.
Best Regards, Tom
Hi, Ben,
If your DSP algorithm is capable to handle the echo noise cancellation, I think your application will be feasible. The AIC3104 and TPA2000D1 require of an external processing for the echo cancellation. So, I see your solution correct to handle…
Part Number: TPA2000D1 Hello,
I would like to adjust the gain of this amplifier to produce a louder audio output. Pins 4 and 5 (GAIN0 and GAIN1) can be used to adjust the gain. The datasheet says the gains can be adjusted by changing the taps on the…
Part Number: TPA2000D1 Hi expert,
My customer have an issue about TPA2000D1 output.
Please refer the attached waveforms.
it seems, not output from amplifier at the timing recovery from shutdown.
They tried to repeat Shutdown pin High and low…
Part Number: TPA2000D1-Q1 Hi, TI guys
In TPA2000D1-Q1 datasheet, it is said that Cbypass should be larger than 10*Ci, but in the application circuit and EVM schematic, the Cbypass equals to Ci, thus i don't know how to select the capacitor value, could…
