Part Number: TPA2011D1 Tool/software: If configuring a 3.2W output, please help check if this circuit matches correctly
If there are any areas that need to be modified, please provide detailed instructions on how to make the changes and the reasons for…
Part Number: TPA2011D1
Tool/software:
We want to use a square wave 1KHz for Audio AMP input that is mean digital signal for input, not analog signal, Is it ok?
Part Number: PCM2903C Other Parts Discussed in Thread: TPA2011D1 Tool/software: Hi, Support Team
our client will use PCM2903C + TPA2011D1 is can workable?
if any suggestion, Please advise me.
Thanks,
Best regards,
Lawrence
Part Number: TPA2011D1 Tool/software: Hi team,
Customer would like to use TPA2011D1 in their application.
They need output DC protection, however, TPA2011 don't get this feature.
Do we get any mono 2W~6W, analog input audio amp part with output DC…
Part Number: TPA2011D1 Other Parts Discussed in Thread: TPA6211A1 Tool/software: Hi
Do you have any suggestions for materials that can replace aw8733 with the same function?
DS_AW8733A_EN_V1.1.pdf
This example is built-in BOOS
T You can also recommend…
Hi Jimmy,
You can refer to equation 14 on data sheet page 19: https://www.ti.com/lit/ds/symlink/tpa2011d1.pdf#page=19
Technically there's no maximum value for this resistor, however too high value would result in very low gain; also note that the value…
Part Number: TPA2011D1 Hi,
We are using Audio codec WM8904 with NXP MCU and has a 1W speaker application.
So we connected Audio codec output to TPA2011D1 speaker amplifier then connected to CDS-20144-L100 CUI Speaker.
When we play the audio sound volume…
Part Number: TPA2011D1
Hi experts,
From the datasheet, TPA2011D1 is a mono device. Customer wonders if they do not distinguish between left and right sound channels, can they use TPA2011D1 drive two 1W 8 ohm speakers?
If not, could you pls help recommend…
Part Number: TPA2011D1
Hello
I am currently using a class D audio amp that can provide 3 W of output power, has a voltage range between 2.8 and 6 V, and has 3 ohms of load (I don't have the part number). I found the TPA2011D1 as a possible alternative…
