Part Number: TPLD-ICS Tool/software: Hello,
As I had issues with counters (see the other post), I decided to fix the problem by resynchronizing the reset signal using 2 DFF on the same clock than the counter.
It worked out for the counter output issue…
Part Number: TPLD-ICS Other Parts Discussed in Thread: TPLD1202 Tool/software: How to produce a square wave with duty=2A and phase=A on TPLD_1202 by inputting a square wave with duty=A？
thanks！
Part Number: TPLD-ICS Other Parts Discussed in Thread: TPLD2001
Tool/software:
Hello,
From the figures of the datasheet showing the counter output timing example when using the high level reset, the output OUT of the counter is shown as being equal…
Part Number: TPLD-ICS Other Parts Discussed in Thread: TPLD1202 Tool/software: We now have two PWM inputs, duty A (60%) and B (50%). Can we output a PWM wave with duty 2 * (A-B) through TPLD1202?
Part Number: TPLD-ICS Tool/software: Hello,
The configuration summary pdf is a nice feature.
However, I feel it lacks the generation within the schematic diagram of the groups (if any) which feels like a lack as the corresponding elements are described…
Part Number: TPLD-ICS Other Parts Discussed in Thread: TPLD1202 Tool/software: Hi,
When using edge detection logic devices, I found that the pulse width output when the corresponding edge is detected is 230ns, which is a bit too long for my current…
Part Number: TPLD2001 Other Parts Discussed in Thread: TPLD-ICS Hello,
I wanted to open a TPLD-ICS related ticket but couldn't find it in the TI part number, feel free to put this ticket in the correct area.
We used to run InterConnect Studio from…
Part Number: TPLD2001
I'm using TPLD-ICS [Rev 1.7.4+1396] to simulate the TPLD2001.
Are the User Registers visible somewhere? I haven't succeeded in finding them, and they aren't mentioned in the User Guide.
[It would be nice to see all the Config…
Yes, you can do this with the analog comparators in the TPLD, but you would need to use a resistor divider to bring the voltage down to within the TPLD's range of 0-VCC of the device (max 5V).
You can build out this design yourself using the online…
Hi Vinesh,
ICS should wait to receive feedback saying that the device has been successfully program before reporting success to the user. Of course, this is clearly not happening in your case.
Please update your InterConnect Studio software to 1.7…
