Part Number: TPS2413 Other Parts Discussed in Thread: TPS25985 , TPS25984 , TPS25984B Tool/software: Hi,
We want used TPS2413 on ~3000W system (12V).
I'm not sure TPS2413 can use with below NMOS RS7E200BG.
Would you please give us some feedback…
Part Number: TPS2413 Hi Expert,
May I have your support to see this case and we also sent the FA to check.
But we need your idea to know more detail and comment as below
When the off-state PSU plug-in to the 12Vbus ( 1 PSU ready and 12.2V is on…
Part Number: TPS2413 I'm using TPS2413 for Oring the two power supplies and my input voltage to ORing controllers was 12 V and I'm getting gate voltage of 23V. Is this Behavior is expected??
Part Number: TPS2413 Hi
The following question needs to check.
Is OK for TPS2413 to drive two MOS? Or do I need two of TPS2413 to connect MOS separately?
Waiting for your feedback, thanks, and regards.
Part Number: TPS2413 I have dual battery packs of between 10.5 14.5 voltage.
I want to power up with pack A if it is available, then when the voltage drops below 10V, (Battery exhausted or removed) seamlessly switch to pack B. Pack B should remain as…
Part Number: UCC39002 Other Parts Discussed in Thread: TSM103 , TPS2413
Hi,
1. Can the voltage of UCC39002 PIN8 is divided as the reference voltage for TSM103 Pin5, as shown in the figure below? Or it can be used by TSM103 without a voltage divider…
Part Number: TPS2413 I used the ORing Power Rail Controller (TPS2413) in 12V input ,the sch as follows ,
When only 12V_1 is on ,The other power will have 2.5V Voltage ,which will drive the LED on .In
http://e2e.ti.com/support/power_management/power_interface…
Part Number: TPS2413 Dear all,
in my design I have two power BUSES ORed together:
BUS1 that is set to 4.9V and controlled by the ORing device TPS2413
BUS2 that can be open or equal to 5.1V
I have a doubt about the reverse current during the 70ns…
