Part Number: TPS2661 I want to know if the TPS2661x family of devices could be used in the following scenario:
I have multiple 4-20mA instruments powered by a single power supply.
I want to protect this power supply from potential shorts between…
Part Number: TPS2661 Hi TIer
I am studying this circuit, and I want to follow this design, using a floating sense resistor and bipolar power supply. Therefore, mA- cannot be connected to the system's GNDA, and I am confused about how VS should be set…
Part Number: TPS2661 Hello,
I use the TPS26610 to protect the two wire 4-20mA analogic input in my design. The device, read periodically the input and power the TPS to take the measure. It can power too the sensor at same time or the sensor can be powered…
Part Number: TPS2661 Hello,
I am in need of more information on the unipolar current limit (IOL) of TPS26613.
Our application uses a 91 Ohm burden resistor. TPS26613 replaces MAX14626.
-Vs and MODE are connected to ground.
+Vs = 3.3V
VSNS and…
Part Number: TPS2661 Tool/software: I want to implement protection for a 4-20 mA analog input from voltage supply (from a voltage source) up to 30 V. It is better if the sensor connection is floating (so that the GND of my circuit does not match one of…
Part Number: TPS2661 Tool/software: How does the TPS26610 reset after a latch-off when input < -Vs? If the input rises above Vs does it automatically recover? Or does it need to be power cycled?
Part Number: TPS2661 Tool/software: Hi,
I have tried to load the TPS2661X model into TinaTi (using the add in macro tool).... When I try to import the model I get the following Issue:
Can this be fixed?
Kind regards
Michael
Part Number: TPS2661 Other Parts Discussed in Thread: TPS2662 Tool/software: Hello,
I'm making a desing to make a user attach an additional external power supply, but I want to make sure it is a good (isolated) power supply and it won't trigger the…
Part Number: TPS2661 Tool/software: Hi TI team,
I have a question about the SBAA551(www.ti.com/.../sbaa551.pdf
I would like to ask if the burden resistor in this design is floating because AINN is not directly connected to GND. And if this is the…
Part Number: TPS2661 Tool/software: I have a question on TPS26614 enable pin.
If we want the output to be disabled by default upon power up, does it work by pulling it down with a 10k resistor? Does the internal pull up causes any problem?
Best…
