Part Number: TPS36-Q1 Tool/software: Hi team,
my customer wants to use TPS36CA66BECDDFRQ1. we have below two questions from d.s.
1. in table 8-2 there's relationship between twc and Ccwd, but actually version C doesnt have CWD pin, is there anything…
Part Number: TPS36-Q1
Tool/software:
Hi,
I hope this message finds you well. We are currently in the process of developing a new hardware product in compliance with ISO 26262 standards. As part of this endeavor, it is essential for us to conduct…
To confirm if this is a device damage because of heavy (110nF) capacitor discharge at the RESET/WDO pin, we mounted new TPS36-Q1 device on a board. We also removed 100nF capacitor on that board before. But the issue persists failing the WDI communication…
Part Number: TPS36-Q1 In an Automotive Project of ours we are using TPS36BA38ACADDFRQ1.
The Reset out is connected to an NMI of MCU,The reset is always high,its not going Low.
The set 0 and Set 1 pins are high,The WDI input is toggled
i have attached…
Part Number: TPS36-Q1 Hi team,
I have a question.
Section 8.3.3 explains that when the MR pin is set to the Low level, the reset pin is also set to the Low level. In this case, will WDI monitoring be ignored and either t_WC or t_WO cleared to 0? …
Hi Junji-san,
The package material information will be the exact same as the TPS36-Q1 device as these devices are both watchdogs in the same DDF(8) package. Could the customer please refer to the 'PACKAGE MATERIALS INFORMATION' on pages 34 and 35 of…
Hi Xiaowei,
We do not have a reference design that shows how the MCU should distinguish between the watchdog RESET pin assertion and WDO pin assertion this would be dependent on the customers safety concept. However, as you mentioned you could likely…
Hi Jimmy,
Is your customer willing to switch to a different window watchdog device? We do have the TPS36-Q1, which has startup delay and watchdog enable/disable functionality. https://www.ti.com/product/TPS36-Q1
Jesse
Part Number: TPS3850 Other Parts Discussed in Thread: TPS3436-Q1 , TPS36-Q1 , TPS35 , TPS3435 Tool/software: Hi Team,
In below configuration of the schematic, the WDO should be kept LOW while WDI is LOW, correct? Is this waveform operation normally…
