Part Number: TPS3808-Q1 Other Parts Discussed in Thread: TPS3710-Q1 , TPS388R0-Q1 , TPS389R0-Q1 , TLV803E , TPS3808E , TPS3808 Hi team, We are using TPS3808G01QDBVRQ1 in one of our applications. Since it is used in a board which is conformal coarted with…
Part Number: TPS3808-Q1 Other Parts Discussed in Thread: TINA-TI Tool/software: Hi team,
We used TPS3808G01-Q1 for monitoring one of the rails in our board. When we are simulating the circuit in ltspice with CT pin in the IC, we observed below behaviour…
Part Number: TPS3808-Q1 Hi Expert,
We found a wired phenomenon on TPS3808-Q1, need your support to check the potential reason.
Below is screenshot for TPS3808-Q1 schematic. When SENSE=730mV, we can see n_RESET=1.2V if we add a 27k pull down resistor…
Part Number: TPS3808-Q1
Hi TI Expert,
Could you help to clarify the definition of the tpHL in the TPS3808-Q1 datasheet?
Not sure which interval it represent based on below diagram.
And we also want to know the max tpHL value, the one in the…
Part Number: TPS3808-Q1 Other Parts Discussed in Thread: TPS3808 , Hi TI Expert,
Could you help to clarify the definition of the RLRESET/CLRESET in our EC table?
What does it looks like in the diagram/Schematic?
I saw same term in TPS3808 E -Q1…
Part Number: TPS3808-Q1 Other Parts Discussed in Thread: TPS3808 Tool/software:
if my sense V is around 5.8V，the reset pin will output high-low alternately，but when I add a 470nf at the sense pin，it wil ok。So，can I add a 470nf？
Part Number: TPS3808-Q1 Please send me the PPAP and any other qual reports for the TPS3808G50QDBVRQ1. I would like to qualify it for a military application. I would also like a part materials list.
Thank you, Jose
Hi,
The C117 value for 25ms delay is incorrect. Please refer to Section 8.3.4 Selecting the Reset Delay Time of TPS3808-Q1's datasheet for the equation.
Why is MR pin connected to 1.8V? Do you want the device to have an always on reset?
Best,
…
