Part Number: TPS549B22 Other Parts Discussed in Thread: TPS548B22 Hi Expert,
I use the TPS548B22 and we face a shortage of that part, Can i directly use the TPS549b22 as a 2nd source? Thanks.
I check the datasheet, i found 2 difference.
1. pin1,2,3 will…
Part Number: TPS549B22 Other Parts Discussed in Thread: USB-TO-GPIO Hi team,
My customer is evaluating our TPS549B22.
They can not detect TPS549B22 on the I2C bus. The measurement waveform is shown below.
The address is 0x10. (1.78k pull down)
And…
Part Number: TPS549D22 Other Parts Discussed in Thread: TPS549B22 , Question:
Can the PMBus pins on the TPS549B22 and TPS549D22 support a 1.8V I/O termination voltage for the pull-up resistors?
Answer:
The TPS549B22 and TPS549D22's PMBus pins are designed…
Part Number: TPS549B22 Hi Team,
My customer is having query on TPS549B22 simulation.
Attached the Simulation report for your reference. Waveform shows ~17.5mVpp but report shows 3.973mV. Can you please clarify.
TPS549B22_0.8V@16.5A.pdf
Regards, Shinu…
Part Number: TPS549B22 Hi,
My customer would like to check is there any CHECKSUM register of the part?
They will need program config and need to check CHECKSUM for double checking if the programming is success.
I can't find CHECKSUM related register in…
Part Number: TPS549B22 Tool/software: WEBENCH® Design Tools Hi. In my device, I have a problem with an output voltage of more than 3.3 V. for еxample, 5 volts. And in program Webench, too, it does not give 5 volts at the output, but only 3.5 V . Resi…
Part Number: TPS549B22 Other Parts Discussed in Thread: TPS548B22 Hi,
For the part “TPS54922RVFR” provide the pin configuration for unused PMBUS pins.
Also, for feedback resistor section, In datasheet it is mentioned that If the output voltage…
Part Number: TPS549B22 Other Parts Discussed in Thread: TPS549D22 Hello, For the pin 27 datasheets specify Not Connect on 549B22 and 549C22. Additionally, the 549B22 datasheet has the pins 26,6and 7 Not Connect. The 549B22 EVM layout has these pins floating…
Part Number: TPS549B22 Other Parts Discussed in Thread: TPS546D24A HI TI expert,
we would like to use TPS549B22 for our design to meet the following requirement:
default Vout=0.84V and need adjust the output voltage on the flying.
I plan to do the design…