Part Number: TPS562201 Hello team,
Do we have risk when 5V is applied to SW pin without Vin voltage? This situation happen due to a customer system use case.
Best regards,
Shotaro
Part Number: TPS562201 I don't know how to test the open-loop bode diagram according to the EVM.
Based on the traditional method, a small-signal is injected between R3, and the TP6/TP5 is chosen as the input.
However, according to actual measurement…
Part Number: TPS562201 Hi team,
My customer is going to use this device and has 1 question.
They will face a situation that only Vout is biased with 5V but Vin is not.
Is there any concern with this?
Would they need to put an external protection circuit…
Part Number: TPS562201
Hi team,
My customer is considering to use this device with Iout= 300mA (typ.). And from the Iout-FSW characteristic in the data sheet and the webench simulation, it is calculated that the switching frequency at 300mA is about…
Part Number: TPS562201 Hello,
I'm an FAE for a distributor that handles TI products. I had a question from a customer about the TPS562201 device. (Question) During board inspection, in the circuit shown in the figure below, 5V is applied to VOUT while…
Part Number: TPS562201 Dear Sir/Ms.
How to calculate the Min on time of TPS562201? I only found the Min. off time in the data manual about 220ns. My colleague's client specs are as follows
Fsw Switching frequency VIN = 12 V, VO = 1.05 V, FCCM mode…
Part Number: TPS562201 Hi team,
My customer want to reduce ripple in light load, so increase L to 6.8uH。
please help make analysis for stability. and suggest other methods to reduce ripple in light load.
Part Number: TPS562201 Hi Sir,
could provide 12v to 1.2v/1A efficiency ciurve? because can't see this curve on datashhet.
and we need calculate Tj max buffer, thanks.