Part Number: TPS62A06A I have an application where a number of TPS62A06A are stacked on top of each other with isolated PSU:s with a series resistance of 0.5 ohm to each of the DCDC. The feedback loop is from the voltage input with an opamp to keep the…
Part Number: TPS62A06A Dear team,
The FIT rate is not on ti.com. It could be missed since it is new relased product. Can you please check. I already contacted CSC but they just anouce us the ti.com link and cannot resolve the issue.
www.ti.com/..…
Part Number: TPS62A06A Tool/software: When I touch the area marked with an arrow in the image below with my hand or a metal object, the output voltage drops abnormally. However, when I measure the output voltage with an oscilloscope and connect the probe…
Part Number: TPS62A06A Other Parts Discussed in Thread: TPS62A06 Tool/software: Hi,
We know TPS62A06A is force PWM and light load efficiency is lower than TPS62A06,
But do you have EVM on hand can help us check the load efficiency as below condition…
Part Number: TPS62A06A Tool/software: Hi,
I have saw startup time maximum is 1ms, I understand this maximum 1ms is based on test condition for "TJ = –40°C to +125°C, VIN = 2.5 V to 5.5 V. Typical values are at TJ = 25°C and VIN = 5 V (unless otherwise…
Part Number: TPS62A06A Tool/software: Hi,
May I know there have any pull down resistor on EN pin internal?
I can't find any pull down resistor on EN pin from block diagram.
Thanks!
Jeff
Part Number: TPS62A06A Tool/software: Hi,
I will use this ic in an array with four DCDC in parallell and four of these in series.
I will measure the current going into each DCDC converter and use the current signal as a feedback signal to reduce…
Part Number: TPS62A06A Other Parts Discussed in Thread: TPS62A06 Tool/software: Hi,
Datasheet mentioned
" TI recommends a feedforward capacitor CFF in parallel with R1 to improve the load transient performance and reduce the output ripple voltage…
Part Number: TPS62A06A Other Parts Discussed in Thread: TPS62A06 Hi,
We found TPS62A06 abnormal star up before EN<1.2V, is it normal?
Any condition may cause Vout early rise up?
Thanks!
Jeff
Part Number: TPS62A06A Other Parts Discussed in Thread: TPS62A02 Hi TI Technical Team,
I have used TI Buck converter, one of the Design.
TI IC used: TPS62A06DRL
Input Voltage: 5.1V
Output required: 3.8V and 3A
I am getting 0.71V output as…