Part Number: TPSM41625 For the ILIM-Function of TPSM41625:
Is RILIM specified for the (5) values in Table 7-12 only - or is any value in between (i.e. 47K) also possible?
Thanks!
Olaf
Part Number: TPSM41625 Hi, I want to use it in an application where nominal voltage is 0.925V. The output voltage can go from 0.9V(min) to 0.95V (max). What should be the resistor value to be used in Rvsel. As in the data sheet, it is given for 0.9 and 0…
Part Number: TPSM41625 I have two TPSM41625MOVR devices in stacked mode - a Primary and Secondary. I am fortunate enough to have a thermal camera to observe the two units. ( - And make sure I don't burn myself. ) The primary operates at about 58*C…
Part Number: TPSM41625 Hi TI Team,
We had found one of the components on the Power Module had been shifted . From X Ray images, it is seen that the component is connected.
PSU100-0091
TPSM41625MOVR
15079
Order No. T04176272
PO#15079
Part Number: TPSM41625 Hello team,
TPSM41625 datasheet figure 8-2 shows output ripple waveform when 12Vin, 0.95Vo and 25A. It shows about 20mVpp output ripple.
Can we reduce the output ripple within 10mVpp by adjusting Fsw, Cout and so on?
My target is…
Part Number: TPSM41625 Other Parts Discussed in Thread: UCD9090A , Hello,
My customer is interested in using the TPSM41625. They typically margin their supplies using the UCD9090A (see Figure 7-22 on pg. 37 of the UCD9090A datasheet). TPSM41625 doesn't…
Part Number: TPSM41625 I would like to use PSpice to simulate the load transients on this device. The pre-configured model works great, however when I add extra capacitance and alter a few of the external resistors to match our design specifications,…