Part Number: TRF37C75 Other Parts Discussed in Thread: TRF37A75 , TRF37B75 , Tool/software:
1.The three power amplifiers IC's TRF37A75, TRF37B75, TRF37C75, can we cascade these 3 IC's to get 45dBm output power for input -7 dBm in S band frequency…
Part Number: TRF37C75 Tool/software: Hello team,
I have a question about SLAM219.zip - S-parameter model.
Is the file obtained with "Simplified Schematic" written in datasheet 1st page?
Best regards,
Part Number: TRF37C75 Hello,
i did not find in the datasheet any information about the powerdown pin control dynamics, that is, the gain variation in dB between the device enabled and the device disabled through powerdown pin. So i'm asking if this measurement…
Part Number: TRF37C75 Hi,
My customer has a selection of RF amplifiers, which are low noise amplifiers and power amplifiers. They are selecting ADI HCM374 and HMC452ST89.
There are also Qorvo SPF5043Z and RF5110G. Attached is the relevant brand model…
Part Number: TRF37C75 Hi team,
Could you please help me with the following questions:
Load at TRF37c75 output is open or short. Which is the maximum allowed reflected power?
TRF37c75 at power down state. Which is the maximum RF power that may be applied…
Hi Durga Prasad,
Looking at your requirements, you need a gain >50dB which is difficult to get in one stage. You can consider Pre driver like TRF37D73 / TRF37C75 from TI in 1st stage then a Power amplifier. Unfortunately TI does not offer last stage…
Part Number: TRF37C75 Hi All,
Can i load the amplifier with 100 ohm output instead of 50 ohm? I have observed the peak-peak voltage drastically increasing when i do that (input current also seemed to increase) Can you tell me the ill effects of this?…
Part Number: TRF37C75 Hello,
We would like to use TRF37C75 in TDD system. We would like to control power up/down by control pin.
Please review the schematic and let us know if there is an issue.
TRF37RF75_circuit_review.pptx
Best regards,
Toshihiro …
Part Number: TRF37C75 Dear Specialists,
My customer is considering TRF37C75 and has a question.
I would be grateful if you could advise.
---
According to the datasheet, PWDN pin has a resistor in the device.
What ohm does it has?
I also would like to…