Part Number: TRF37D73 Tool/software: Dear Specialists,
My customer is considering TRF37D73 and has two questions.
I would be grateful if you could advise.
---
I am considering TRS37D73 for 1ns pulse amplification,
Could you please answer the…
Part Number: TRF37D73 Other Parts Discussed in Thread: LMH6401 Tool/software: TRF37D73 has a separate pin that looks like bias (pad 1) but it says in the datasheet that it has to be connected to VDD.
Can I regulate amplifier gain by varying that voltage…
Part Number: TRF37D73 Tool/software: Hello!
We have a mature design containing the TRF37D73.
Recently we realised that on some boards current, consumed by the TRF37D73, is extremely high - up to 350mA.
The amplifier at this state is operational…
Part Number: TRF37D73 Hello, The datasheet states TRF37D73 works at 1MHz to 6GHz range. My customer would like to use TRF37D73 at 10MHz. However, all plots in the datasheet do not show performances below 300MHz range.
Is TRF37D73 really able to be used…
Part Number: TRF37D73
Hi，team
My customer has the following questions,
“When I import a TRF37D73 ADS2014 Model file to ADS，I can import them successfully.But in the simulation,the emulator reported an Erorr detected by hpeesofsim during netlist…
Part Number: TRF37D73 Good morning, I'm looking at using the TRF37D73 in an application from 1-30 MHz. The datasheet plots for OP1dB stop before they reach this frequency range, so I'm unsure if there's a roll-off in performance. Do you have any data…
Part Number: TRF37D73 Hi;
I saw there are some differences between the schematic on datasheet and on the TRF37x73 and TRF37x75 EVM user's guide. in the later, there are two resistors, R1 and R2, in VCC and output inductor;
but there is no those…
Part Number: TRF37D73 Other Parts Discussed in Thread: OPA3S2859 , OPA855 , OPA858 Hello,
I am looking to use this RF gain block as the first stage in a photodetector application. I was wondering if there is a real resistor to ground from the RF input…
Part Number: TRF37D73 dear
TRF37D73Z is used for output amplification in 5.8ghz band of WiFI6 router, and the compression point of output 1dB is only 15dbm, is it because the output impedance is not well matched? Need conjugate matching of output impedance…
