Part Number: TXG1041 Hello E2E Experts,
Good day.
TI's website/datasheet shows the part marking for TXG1041DBQR to be "TXG141".
DigiKey received parts under PO 4731505 delivered April 15th 2025 from TI with the part marking "TXG841". Can you confirm…
Part Number: TXG1041 Tool/software: DigiKey on behalf of end customer.
Customer ordered the TXG1041DBQR and the product they have has the marking TXG841. The TI marking tool states the marking should be TXG141. The same tool could not connect the…
Part Number: TXG1041 Other Parts Discussed in Thread: TXG8041 , Tool/software: We require the IBIS model for the TXG1041DBQR component to perform signal integrity simulations for our high-speed circuit board. Additionally, we would like to request the…
Part Number: TXG1041 Other Parts Discussed in Thread: TXG1042 Hello,
I would like to request clarification regarding the “Isolation rating: Functional” listed on the TXG104x (TXG1041 / TXG1042) product page.
In the datasheet, the device is described…
Other Parts Discussed in Thread: TXG1041 FAQ: Logic and Voltage Translation > Ground-Level Translators >> Current FAQ
The leakage between two grounds can be found under the Electrical Characteristics section in the datasheet.
Using the TXG1041 datasheet…
Part Number: TMUX8212 Other Parts Discussed in Thread: TXG1041 , LM2665 Tool/software: Hi TI Team;
Can I power the TMUX8212 with only a negative supply? I would like switch negative voltages.
Example: VDD = 0V; VSS = -36V
If that is not possible…
FAQ: Logic and Voltage Translation > Ground-Level Translators >> Current FAQ
TXG devices (both push-pull and open-drain) cannot support any level of IEC-ESD. However, IEC-ESD can still be achieved by using a protection device like the ESDS30x product…
FAQ: Logic and Voltage Translation > Ground-Level Translators >> Current FAQ
At the moment TXG QFN packages do not support wettable flanks. However, we are working towards supporting wettable flank packages once products are fully released.
The QFN…
Other Parts Discussed in Thread: TXG8122-Q1
Since the I2C protocol limits the allowable bus capacitance to 400pF (for Standard and Fast Mode) or 550pF (for Fast Mode+), similar requirements will need to be implemented on the TXG8122-Q1.
There are…
