Part Number: TXU0101 Other Parts Discussed in Thread: TXU0104 , TXU0202 , TXU0102 , TXU0204 , TXU0304 I can't find an IBIS model for this part? Is there an IBIS model for this part? Is it the same with TXU0104? Thank you
Part Number: TXU0101 Hi,
I found the LXC parts says:
If either VCC supply is < 100 mV or disconnected, all I/O's get pulled-down and then become high-impedance
But TXU says:
If either VCC input is < 100 mV or disconnected, all outputs are disabled…
Part Number: SN74AHC1G125 Other Parts Discussed in Thread: TXU0101 , TLV7011 Hi Team,
My customer needs a buffer device which has higher V IL threshold compared to the SN74AHC1G125. They're looking for 1.8V at Vcc = 3.3V. Is there any device with this specification…
Part Number: LSF0204 Other Parts Discussed in Thread: LSF0102 , 2N7001T , SN74AUP1T34 , SN74AUP1G125 , SN74AUC1G125 , TXU0101 , SN74LV1T34 Hi team,
My customer is looking for 13.3V to 1.8V 3-ch level translator which supports I2C and SPDIF.
Does LSF0204 support…
Other Parts Discussed in Thread: TXU0101 , SN74AUP1G17 , OPA863 1MHz, 3.3v square wave (clock) with 50% duty cycle, can its amplitude be reduced to 2.7v using an op-Amp buffered powered with 2.8V single ended power supply?
Part Number: TCA5405 Other Parts Discussed in Thread: LSF0101 , 2N7001T , TXU0101 , SN74LVC1G07
Hello E2E Experts,
Please share the internal structure of the TCA5405 to understand what should be the value of the pull-down resistor in the attached…
The rise/fall rate is not directly related to the frequency; it describes the slope of the signal edges, not the interval between the edges. If your signal has slower edges, you need to use a different device, probably with Schmitt-trigger inputs.
1. Yes, the worst-case current is 1.5 mA. However, the typical current is much lower; the left curve below shows the characteristics of an LV1T input with a 5.0 V supply:
(Ignore the right curve; it's for devices without level shifting.)
2. If you…