Part Number: MSP430FR5739
Hi,
I have purchased MSP430FR5739 recently. I have following questions would like to ask.
Firstly allow me describe my set up.
After I have downloaded program from USB, I disconnect usb and power the board from #1…
power off then on, 3rd sample and other is bad.logicdata.txt 1. As you (and data sheet) mentioned, /DRDY "returns high after the first falling edge of SCLK during a data read operation". Since /DRDY only has 1 channel to sample, perhaps it is staying…
Other Parts Discussed in Thread: LM5050-1 , TPS2490 , TPS2552 Many times a power design will have multiple inputs. Diode ORing is the term used to allow automatic selection of the input source.
Usually the diode that is shown is just a representation…
Part Number: DS90UB927Q-Q1
Hi team,
customer use 927+948, the LVDS and I2C can work normally, but the GPIO0-3 can't mapping and always low.
below is the 927 and 948 register setting, can you help to check it? thanks,
927
Fullscreen…
Part Number: TIDA-00701 Other Parts Discussed in Thread: TIDA-00701 , UCC28051
Hi,
I am designing a 100W 24V power supply as detailed in design note tida-00701 and I have a few queries regarding the design:-
1) Page number 45 section 7.4 of the…
Part Number: LP-MSP430FR2476 Other Parts Discussed in Thread: MSP430FR2476 I'm trying to set up an I2C connection where a VL6180X-SATEL is the slave device with the master device being the MSP430FR2476. From what I've read from design documents I believe…
Table 4-3 in the data sheet is defining the available current that can be sourced from the DIAG _OUT when the analog mux is chosen and active. In other words if you choose VDD5 (0x04h) then the output would be a 2.5V (+/- 2%) output that can supply (2…
Based on trying to use a High Speed CAN transceiver (differential pair, centered on Vcc/2) in this sort of mis-use case as a single wire CAN transceiver, single ended referenced to GND it will be very difficult. Even using a 5V CAN transceiver you are…
