Hey Richard,
Sorry for the delay in response, SOIC opens many doors. You could use an integrated difference amplifier, however, the outputs will not swing all the way to either rail, so you will begin to lose accuracy close to 0V. Additionally, there…
HI Purvik,
If we look at the XTR111 data sheet Figure 40, this shows the noise performance at the output of the XTR111 (XTR stand alone) after using an output RC low pass filter of 10kΩ and 10nF. Please note, this accounts for the ripple noise inherent…
Part Number: AM62X-PET-CALC Tool/software: Dear TI support
I am new to u-boot and binman. We are working with TI team on secure boot image signing for TI customers. Our TI business contact told me that you used u-boot and switched to binam to build and…
Part Number: TPSM843A22 Dear Sirs and Madams,
We are considering using TPSM843A22.
I downloaded the " TPSM843B22-A26-A22-CALC " of calculation tool from the website, but it appears that I cannot use it.
Please could you confirm this problem and…
Hi Sid,
No, the path cost changes. Sometimes the path cost value is usual but incorrect, for example, 3, 4, or 6, and at other times, the value is extremely high, above 100 or 200. I'm sharing with you a log from one device that we generated during our…
Hi Patrick,
The probe connected in my setup is a TDP1500 - it has 200K differential input resistance, is that fine? https://www.tek.com/en/datasheet/differential-probes
sensor min freq 8/3 = 2.67MHz seems a better fit for our device which operates at…
Hello, Timothy.
I am the customer Mr. Jeong mentioned. I have a question following your answers.
Q1. To be specific for our requirment of Buck(LM5141), Target input V is 48 and the range is min 12V ~ 65V. Output power requirment is that Vout is 5V, Iout…
Hi,
Yesterday I was further investigating this subject trying to point out where / what issue could be with the EVM.
I found out when the EVM is cooled down to 6-10 degrees celsius, and i press U29 with my finger downwards the EVM indeed does boot, and…
Hii Onkar,
I have attached the sheet and below is the Section of schematic for reference,
Also I have tested this circuit with Cout : 132 uF and 176 uF but same behavior is there.
Regards,
Virendra
1050.TPS54360-361FAMILY_CALC_TOOL_REVE.xls