Part Number: XTR105 Hello,
We had used XTR105U current transmitter IC in one of our previous designs. Currently its status is 'Last time buy'. So we were looking for its substitute. We found one part in the same series XTR105UA/2K5 as per the website…
Part Number: XTR105 Hi
what is the difference between XTR105U and XTR105U A (the additional A )
is it just a logistic difference ?
I couldn't understand it from the datasheet
thanks
Raz
Part Number: XTR106 Other Parts Discussed in Thread: XTR105 Dear Team,
what are the differences between XTR106UA vs. XTR105UA?
Can XTR105UA be used as an alternative to XTR106UA? Is there something not obvious that one needs to pay attention to?
Rega…
Part Number: XTR105 Jul 172023 ordered XTR105PA 100 tablets from Mouser, order number: 29530005 inspection found that most of the foot root has a crack (see figure) . Is this situation caused by the production process or the device itself
Part Number: XTR105 Hi team,
One of our customers asked about the 40:1 result calculation process. Can anyone share how it was calculated or explain how it was obtained?
Best Regards,
Amy Luo
Part Number: XTR105 Other Parts Discussed in Thread: XTR101 Hi,
Is there any test result data available for XTR105 MTBF.Can you share with me if anything available.
Earlier we used XTR101 for RTD to 4-20mA loop current generator and we switched to XTR105…
Part Number: XTR105 Other Parts Discussed in Thread: XTR116 , XTR115 , XTR111 I've been trying to create two signal converter circuits for Arduino Dues. These circuits would be used to interface the board with 4-20mA enabled industrial devices:
1) Voltage…
Part Number: XTR105 Other Parts Discussed in Thread: XTR111 Good Morning,
I've developed a sensor (3 electrodes) 4-20mA for chlorine measurement.
The interface with the external instrumentation is entrusted to XTR105. I'm using the Iret like the …
Part Number: XTR105 Other Parts Discussed in Thread: XTR106
Hi Team,
Please find the schematic for resistive bridge application. I find the linearization correction with RLIN in datasheet is for RTD application. Could you please give some guide on how…